Exterior and Interior Test

Technician A says that the lower the metric pitch, the coarser the thread. Technician B says that separate gauges are required to measure SAE and metric pitches. Who is correct?

• a. Tech A
• b. Tech B
• c. Both
• d. Neither
• Pluto

SAE thread pitch is:

• a. the number of thread per inch
• b. the distance between two adjacent threads
• c. measured in millimeters
• d. the number of threads plus two

The higher the thread pitch number on a metric fastener the:

• a. finer the thread
• b. coarser the thread
• c. smaller the fastener
• d. larger the fastener

A flat washer is used to:

• a. hold the bolt and nut in place
• b. limit corrosion to the bolt
• c. reduce stress
• d. be a sacrificial component

Generally, torque wrenches should be calibrated at least once:

• a. every five years
• b. quarterly
• c. a year
• d. every three years

Technician A says that hardware should be divided and put into labeled parts location bins. Technician B says that hardware should be stored in labeled sealable bags and attached to the removed or replacement part. Who is correct?

• a. Tech A
• b. Tech B
• c. Both
• d. Neither

Which of these adhered emblem removal methods uses a see-saw cutting motion?

• a. air chisel attachment
• b. small razor blade tool
• c. heat application
• d. fishing line

Which of these can be used to remove an OEM emblem attached with two sided tape?

• a. Penetrant oil
• b. hacksaw blade
• c. eraser disc
• d. fishing line

Which of these adhered emblem removal methods uses a circular motion?

• a. air chisel attachment
• b. small razor blade tool
• c. heat application
• d. fishing line

Technician A says that when removing a belt molding the door trim panel may need to be removed. Technician B says that when removing a belt molding the window may need to be removed. Who is correct?

• a. Tech A
• b. Tech B
• c. Both
• d. Neither