Skydio Drone Bridge Upward Scanning Quiz

Which action does the Skydio drone automatically perform when the height of the drone is below the specified scan Surface during 2D Upward Capture?

• Moves the camera gimbal pitch to look up

• Lands the drone immediately

• Increases the flight altitude

• Turns off the camera

Why is it recommended to set pillars underneath or at the edge of a bridge when scanning narrow bridges?

• To help the drone relocalize during multi-battery scans

• To increase the scanning speed

• To reduce the number of images captured

• To avoid battery drain

For Skydio X2 Color/Thermal users, what Distance to Surface is highly recommended when scanning homogenous surfaces?

• About 32 ft (10 m)

• About 10 ft (3 m)

• About 5 ft (1.5 m)

• About 50 ft (15 m)

What happens to the gimbal angle when capturing the bridge deck in a 2D Upward Capture?

• It will automatically look down to capture the bridge deck

• It will remain fixed at a horizontal angle

• It will rotate 360 degrees

• It will point upwards

In DroneDeploy, which option should you select to add images to create a facade model of a structure?

• Vertical Model

• Map or Model

• Photo Report

• Panorama

Which of the following is required in Map Capture scan mode?

• Bluetooth connection

• GPS

• Cellular data

• Infrared sensor

What should you do if you plan to scan in a location without an internet-enabled Wifi connection?

• Increase the drone speed

• Import the map beforehand

• Disable thermal image capture

• Change the gimbal angle

Which of the following is the default speed setting for exploring and scanning in Map Capture mode?

• 2.5 mph (1.1 m/s)

• 5.6 mph (2.5 m/s)

• 10 mph (4.5 m/s)

• 7.0 mph (3.1 m/s)

Which setting is ON by default in Map Capture mode, according to the table?

• Strict Geofence

• Modify Scan Volume

• Take Best Photo

• Increase Overlap/Sidelap

If you rename a scan in the Map Capture Workflow, what will happen?

• The scan mode will be reset to default

• The scan mode will be replaced in the scan name

• The scan will be deleted

• The scan will not save