OrCAD Capture Simulation and Schematic Basics

The video tutorial guides students through reworking problem 5.37 using PSpice in applied circuit analysis. It covers setting up the software, creating a new project, placing components, wiring the circuit, and running simulations. The tutorial also addresses common issues and provides solutions, ensuring students can successfully complete the task.

What is the first step to take when starting a new project in OrCAD Capture?

• Run a simulation

• Import a schematic

• Create a new project

• Open an existing project

Why is it recommended to use the analog ground symbol in your schematic?

• It is required for digital circuits

• It is only needed for AC analysis

• It reduces simulation time

• It simplifies the schematic

What should you do if the probe icons are grayed out in OrCAD Capture?

• Reinstall the software

• Restart the program

• Check for admin access

• Update the software

How can you rotate a component in the schematic?

• Right-click and select rotate

• Use the rotate tool in the toolbar

• Double-click the component

• Press Ctrl + R

What is the purpose of setting up a simulation profile?

• To save the project

• To configure the simulation settings

• To print the schematic

• To export the results

What should you do if the simulation shows zero volts across components?

• Check the power source configuration

• Increase the simulation time

• Add more components

• Restart the simulation

How can you view the current through each branch in the schematic?

• Run a DC sweep

• Enable current display

• Check the simulation log

• Use the voltage probe

What is the significance of a bias point in simulation?

• It shows the DC steady state currents

• It is used for transient analysis

• It represents the AC response

• It is only relevant for AC circuits

What should you do if you need to change a resistor value in the schematic?

• Right-click and select properties

• Double-click the resistor value

• Double-click the resistor itself

• Use the edit tool in the toolbar

What is the final step after setting up and running a simulation?

• Save the project

• Print the schematic

• Export the results

• Close the software