NEW
Font size
WorksheetsEffects Processing
Total questions: 17
Worksheet time: 9mins
Peak Meters are use to
indicate the constant level of a signal
indicate the transient peaks of a signal
indicate the constant peaks of a signal
VU meters are used to
indicate the average constant level of a signal
indicate the transient peaks of a signal
indicate the constant signal of a signal
A shelving filter is
a filter with a bell shaped curve around the filters' active frequency
a filter with a constant level after reaching the filters active frequency
a filter that cuts the high frequency component of a signal
a filter that cuts the low frequency component of a signal
A high pass filter is
a filter with a bell shaped curve around the filters' active frequency
a filter with a constant level after reaching the filters active frequency
a filter that cuts the high frequency component of a signal
a filter that cuts the low frequency component of a signal
A low pass filter is
a filter with a constant level after reaching the filters active frequency
a filter with a bell shaped curve around the filters' active frequency
a filter that cuts the high frequency component of a signal
a filter that cuts the low frequency component of a signal
A peak filter is
a filter with a bell shaped curve around the filters' active frequency
a filter with a constant level after reaching the filters active frequency
a filter that cuts the high frequency component of a signal
a filter that cuts the low frequency component of a signal
.A compressor is
an automatic fader
a gain control
a device that can reduce the dynamic range of program material
All answers are correct
A downward expander
decreases the gain of loud signals
increases the gain low level signals
increases the power of a signal linearly
decreases the gain low level signals
Headroom is
the level between the floor noise and the signal level
the level between the minimum and maximum dynamic range
the operating room between 0 db and distortion
the area above the distortion level in a system
Which of the following is not related to dynamic level processing?
flanger
limiter
gate
expander
An aural exciter alters the high harmonic content of an audio signal.
True
False
The timbre or tone color of reverb is generally darker than the original sound.
True
False
Reverb time (RT 60) is the amount of time it takes for a reverberated signal to reach -60db below the direct sound level.
True
False
What does the "Q" of a filter refer to
resonance
bandwidth
resonance and bandwidth
none
Which type of equalizer divides the frequency spectrum into several narrow bands?
graphic
parametric
graphic and parametric
none
Why are gates used when miking a drum kit?
used to isolate drum sounds on a track
to allow drums to bleed together in mix
which control is not typical on a compressor?
Threshold
Attack
Release
Ratio
Frequency
