Worksheetsbelt disc sander
Total questions: 15
Worksheet time: 8mins
When using the belt and disc sander you should...?
wear safety goggles
mess around
talk to your neighbor
all of these
You should make sure that there are no blank between the belt or disc and their respective tables before turning the machine on.
nothing
scrap pieces
paper
clothes
When you are done using the belt disc sander you should do what?
turn the machine off
leave the machine on for the next person to use it
turn the machine off and stay in the work zone until it has stopped
What should you do if a piece of wood gets trapped between the belt or disc?
turn the machine off and clear it out
turn the machine off, wait till it stops, then clear it out
take the wood out while the machine is running
If you are using the belt/disc sander you should do which of the following?
wear safety googles
tuck in close if necessary
roll up your sleeves past your elbows
all of these
Before turning on the belt/disc sander you should...?
check and adjust the table
eat a snack
talk to your friend
ask the instructor what to do if you don't
After the belt/disc sander has been turned on what should you do?
start sanding right away
wait till the sander is up to full speed then start sanding
check if the machine is up to full speed with your hand
You should force the stock into the belt or disc?
yes
no
Should you keep your fingers closer than 1 inch from the blade?
yes
no
If the machine breaks what should you do?
turn off the machine and try to fix it yourself
turn of the machine and notify the instructor
try to fix it yourself
throw it across the room
You should sand small pieces of wood with the belt/disc sander?
no
yes
no, you should sand those by hand
You should keep the stock on the table while sanding?
yes
no
Before turning on the sander you should...?
make sure the stock isn't touching the belt of disc
get your stock ready by touching it the the belt or disc
have your friend hold your stock for you
You should force the stock into the belt of disc?
yes
no
If you turn the sander on and you notice that the belt or disc is not tracking correctly you should do what?
turn the machine off
turn the machine off and notify the instructor
sand anyway
try to fix it yourself
