WorksheetsIntro to Tech MCA: Woodworking
Total questions: 10
Worksheet time: 5mins
What side of the board is the Edge?
A
B
C
What side of the board is the Face?
A
B
C
What side of the board is the End?
A
B
C
What direction does the grain of the wood run?
End to End
Edge to Edge
Face to Face
Edge to End
What two saws are used exclusively for cross cutting?
Table Saw and Radial Arm Saw
Band Saw and Miter Saw
Miter Saw and Scroll Saw
Radial Arm Saw and Miter Saw
What direction should you sand in?
It does not matter
With the grain of the wood
Against the grain of the wood
Diagonally across the grain of the wood
When is comes to sanding you should:
Start with the lowest number grit and work your way up
Start with the biggest number grit and work your way down
Start with the middle and work your way up then down
Start with the middle and work your way down then up
How much material does one pass on the jointer remove?
1/2"
1/4"
1/8"
1/16"
Why is applying finish necessary?
Because we like our projects to look pretty
Because it locks in the moisture content of the wood
Because it makes it insect resistant
Because it prevents splinters
Why does wood twist, warp, and or cup?
The wood dried
The wood was twisted, warped or cupped when originally cut
The wood was left in the sun too long
The wood is old
