NEW
Font size
S
M
L
XL
WorksheetsCCNP-Tshoot-Pre-Assessment
Total questions: 15
Worksheet time: 15mins
Name
Class
Date
1.
Latest version of OSPF
a)
OSPFv2
b)
OSPFv3
c)
OSPFv5
d)
OSPFv6
2.
Which of the following is Multicast Protocol
a)
ICMP
b)
RIP
c)
IGMP
d)
OSPF
3.
How to enable IPv6 on router
a)
Router(config)#ipv6 Routing
b)
Router(config)#ipv6 unicast-routing
c)
Router(config)#ipv6 route
d)
Router(config)#enable route ipv6
4.
Which switch mode allows only VLAN information pass-through
a)
Client Mode
b)
Transparent Mode
c)
Management Mode
d)
Server Mode
5.
BPDU send every
a)
5 sec
b)
2 sec
c)
3 sec
d)
None of the above
6.
Which command make switch as router
a)
Router(config)# ip v6 unicast-routing
b)
Router(config)# ip routing
c)
Router(config)# frame-relay routing
d)
Router(config)#frame-relay ip switching
7.
Trunking Protocol (Layer 2)
a)
Dot1q
b)
RIP
c)
BGP
d)
STP
8.
Which command to be initiated to make SSH feature on Router/Switch
a)
Router(config)#ip domain-name ccna.com
b)
Router(config)#ip ssh version 2
c)
Router#ip ssh
d)
Router(config)#crypto key generate rsa modulus 1024
9.
How to verify Bridge Priority value
a)
Switch#Show interface trunk
b)
Switch#show interface port-security
c)
Switch#show spanning-tree
d)
Switch#show run
10.
How to verify EIGRPs “K” values
a)
R1#Show ip route
b)
R1#Show Ip protocols
c)
R1#Show ip interface brief
d)
R1#Show run
11.
Which statement is true about an IPsec/GRE tunnel?
a)
The GRE tunnel source and destination addresses are specified within the IPsec transform set
b)
Crypto map ACL is not needed to match which traffic will be protected
c)
An IPsec/GRE tunnel must use IPsec tunnel mode
d)
GRE encapsulation occurs before the IPsec encryption process
12.
Which IPsec mode will encrypt a GRE tunnel to provide multiprotocol support and reduced overhead
a)
tunnel
b)
transport
c)
Mutipoint GRE
d)
3DES
13.
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?
a)
This is a 10 Mb/s switch port.
b)
This is a 100 Mb/s switch port.
c)
This is an Ethernet port operating at half duplex.
d)
This is an Ethernet port operating at full duplex.
14.
Which layer in the OSI reference model is responsible for determining the availability of the receiving program and checking to see if enough resources exist for that communication
a)
transport
b)
network
c)
session
d)
application
15.
A receiving host computes the checksum on a frame and determines that the frame is damaged. The frame is then discarded. At which OSI layer did this happen?
a)
session
b)
transport
c)
network
d)
datalink
Reset
