Font size
WorksheetsModule 6 BIOS/CMOS 1
Total questions: 12
Worksheet time: 6mins
Basic Input/Output System (BIOS) job is to perform initial hardware checks when the computer is turned on and start the operating system.
True
False
Which two resources can be used by an Operating System (OS) for communication with hardware?
Device Manager
Secure Shell (SSH)
Device drivers
System BIOS
Command-Line Interface (CLI)
Updating or replacing the BIOS contents in a PC is called:
Hard boot
Overclocking
Flashing the BIOS
Direct memory access (DMA)
Why do you perform BIOS updates? (Select all that apply)
Repair damaged BIOS
Fix physical hardware faults found in replaceable components inside the computer's case
Provide support for new types of attached hardware
Fix known programming errors discovered in the current BIOS version
BIOS types that can be updated without removing the BIOS chip from a motherboard are called? (Select 2 answers)
EEPROM
ROM
Plug and Play (PnP)
EPROM
Flash Memory
Power failure during BIOS upgrade does not result in irreversible damage to the computer system.
True
False
Because BIOS is stored on a ROM chip, a normal system shutdown causes allows the contents of the memory used to store BIOS settings to:
Be erased
Be retained
Be Stored in a page file
Be saved on a hard drive
Which acronym refers to a series of basic hardware diagnostic tests performed by the startup BIOS when the computer is powered on?
IDE
POTS
QoS
POST
Select the two places specific parameters of a new device are stored after replacing a modular hardware component inside computer case.
System BIOS
Flash memory
Startup BIOS
Secondary storage
CMOS RAM
Once the initial diagnostics are performed and assigning system resources, the startup BIOS program will check for information about secondary storage devices that might contain the OS. This list of devices and the order in which they should be checked are found and arranged in the CMOS setup utility, and are commonly referred to as:
The Boot Record
The Boot sequence
The MBR (Master Boot Record)
The Disk Partition table
For an integrated component like a NIC card to work on a newly assembled computer system, what might you have to do first?
Enable it in Windows Control Panel
Update it with the latest driver in Device Manager
Check it against the Hardware Compatibility List (HCL)
Enable it the advanced BIOS settings menu
When launching Windows Virtual PC application a technician receives an error message that the Hardware-Assisted Virtualization (HAV) feature is not enabled on the computer. Which steps might help to fix the problem?
Safe mode troubleshooting
Re-install the Windows Virtual PC application
Get into the CMOS setup utility and enable the virtualization technology setting
Increase the amount of physical RAM on the system
