An atomic force that can attract and repel ferrous substances is known as:

Tech A says an insulator is a substance that resists the flow of electricity. Tech B says the atoms in an insulator are very stable and resist electron movement. Who is right?

Electrical pressure that causes current is known as:

Tech A says dc circuits are not normally used in automotive circuits. Tech B says certain automotive computer sensors use ac. Who is correct?

Tech A says a series circuit has only one path for current. Tech B says a series circuit can have only one load. Who is right?

CAN bus C is a ___________ speed network.

Two technicians are discussing relays. Tech A states that a set of normally open (NO) contacts will have continuity when the relay is in the off position (i.e. not energized). Tech B states that a set Of (NC) contacts will have continuity when the relay is in the “off” position (I.e. not energized). Which technician is correct?

Conventional current flow is from:

Tech A says that a good test of an alternator charging system is to remove the battery positive cable off the battery post, and see if the engine dies. Tech B says that the practice of removing a battery cable connection while the engine is running can damage the electronics on the vehicle. Who is correct?

And ignition coil is an example of:

Which of the following is not part of the supplemental restraint system (SRS):

True or false. Some networks transmit and receive signals over a single wire, but those with dual wires commonly call the two signal wires: “CAN-bus high” and “CAN-bus low” with the same message sent on both lines.

Tech A says a resistor is it designed to extract energy from the current flow. Tech B says that a DVOM can be used to check for a voltage drop. Who is correct?

Two technicians are discussing battery load testing. Tech A says that if the battery fails the load test, it is bad and should be replaced. Tech B says if it fails the load test, it should be fully charged and the test repeated. Who is correct?

The ___________________ monitors battery voltage and varies current flow through the rotor field circuit.

Tech A says you must have a power supply for a simple circuit to work. Tech B says a switch will interrupt current flow. Who is correct?

True or false: increasing the resistance of a variable resistor wired in series with a lightbulb will affect the amperage through the lightbulb.

Tech A says AC stands for alternating voltage. Tech B says DC is used in electric motors on most hybrid vehicles. Who is correct?

To conduct a ‘continuity’ test with an ohmmeter, circuit power is: