NEW
Font size
Worksheetsunit 10 level 1 Dip Bench Joinery
Total questions: 20
Worksheet time: 14mins
In order to maintain accuracy with setting out tools, they should be:
Used by 1 person only
Shared between colleagues who use them correctly
Stored in your tool box correctly at night
Checked and maintained regularly
Which of the following is not a reason for storing tools correctly?
Prevent theft
Prevent damage
Prevent loss
Prevent overworking them
Which of the following holding devices is best suited for clamping frames?
Sash clamp
G clamp
Bench hook
Vice
This tool is used to cut curves in timber and thin sheet materials , can you name it ?
senior hacksaw
coping saw
junior hacksaw
The chisel in the image is damaged and would need Grinding . What angle should the chisel be Ground back to ?
25 degrees
45 degrees
30 degrees
Hardpoint saws are NOT re-sharpened and are just replaced?
true
false
When re-sharpening a traditional saw what is correct sequence for re-sharpening it?
Topping, shaping, setting and sharpen
Sharpen, setting, shaping and topping
Which of the following planes is most suitable to use when forming grooves?
Plough
Rebate
Router
Shoulder
After honing the 30 degree cutting edge on a chisel, what forms and will need removed from the flat back side of the chisel?
Dirt
Burr (AKA 'Birr')
Tree resin
When maintaining Joinery Hand tools, what two pieces of PPE are most useful?
Hard hat and vis vest
Work trousers and safety boots
Eye protection and Gloves
What is the name given to the splinters and damage caused if a drill is allowed plunge straight through a piece of wood?
swarf
Burr
Breakout
