WorksheetsManufacturing routine joinery products
Total questions: 20
Worksheet time: 10mins
Which one of the following is not a health hazard?
Dust
Noise
Saw blades
Musculoskeletal
What scale are workshop rods usually drawn?
1:1
1:5
1:20
1:250
Name a document that is used for additional information that go's along-side of an architect's drawing?
Specification
Job sheet
Schedule
Building regulations
What's does the term 'nominal size' mean?
Standard timber dimensions
The planed timber dimensions
The saw timber dimension before machining
The total length of timber required
What Building regulation controls the rise and going of a staircase?
Approved document A
Approved document E
Approved document G
Approved document K
If a discrepancy is discovered between the setting out drawing and the building regulations, what action should you take?
Contact the structural engineer
Contact the architect
Report the issue to your line manager or supervisor
Amend the drawing
When should a cutting list be produced?
After the setting out has been completed and checked
Before producing the rod
As soon as you receive the specification
As soon as you receive the elevation drawings from the architect
Which one of the following machines is normally used first when preparing timber for routine joiner?
Morticer
Spindle moulder
Rip saw
Cross-cut saw
Which one of the following is a type of collective protective equipment?
RPE
LEV
PPE
CPD
What does the abbreviation LEV mean?
Light extraction ventilation
Long extraction ventilation
Light exhaust ventilation system
Local exhaust ventilation system
What material is best for protecting the steps on a staircase?
Dust sheet
Hardboard
Bubble wrap
Old newspaper
What does the abbreviation 'PSE' mean?
Planed square, and edged
Planed all round
Planed straight and edged
Plane, shaped and equal
Which of the following materials is suitable for use externally?
MDF
Chipboard
WBP plywood
Blockboard
Which of the following adhesives foams up as it dries?
Mitre mate
Animal glue
PVA
Polyurethane adhesive
Which of the following metals is a 'ferrous metal'?
Copper
Aluminium
Steel
Brass
Which of the following timbers are for external use?
Southern yellow pine
Beech
Balsa
Cedar
Before setting a machine ready for use you should always...
Adjust the guards
Oil the spindle
Check the blade or cutters are sharp
Isolate the power
Which of the following clamps are best used to assemble window frames?
T bar clamp
Sash clamp
F clamp
Quick clamp
What's the best method to use for squaring a frame?
A try square
Measure the diagonals using a squaring rod
Use a tee square
Use a combination square in a four corners
How should you check to see if a frame is free from twist?
Use a long spirit level on the face
Use a combination square
It's unlikely that it'll be in twist, you don't need to check it
Sight through the frame to make sure opposite sides are parallel
