Outlets should average one for every ___ feet of wall space.

Choose the correct door swing.

What is the minimum clearance distance in front of a sink?

In residential construction, what is the minimum width of a half bath?

What is the correct symbol for a Hose Bib in the image shown?

What is the correct symbol for a standard 110v/115v outlet in the image shown?

Residential floor plans are always drawn at a scale of 1:50.

1/4"=1'-0" and 1:48 scale are the same.

The soil stack is a vertical soil pipe carrying the discharge from the toilet fixture.

When showing stairs on a floor plan you should always show and arrow going up but not going down.

A hearth should always have a finish elevation of 0'-0".

The ADA codes are always used in residential drawings.

Doorknobs on doors can be operated more easily than levers.

GFCI outlets should be installed near any water source.

All outside outlets do not need to be weatherproof outlets.

Floor plans should only be drawn at 1/4"=1'-0".

Solid concrete or block walls are dimensioned the same as wood construction. (10-34)

Sub-dimensions must add up to overall dimensions.

Heating and cooling equipment located in a garage must be protected from impact. This is generally done by placing what in front of the equipment?

The minimum size door required to access HVAC equipment is:

Suspended HVAC equipment must be at least ____ from the ground.

Factory-made ducts must be approved and labeled by:

When ducts must be run between floors, they need to be run in a(n):

If a residential or commercial structure cannot be uniformly heated or cooled from one compressor a ____system may be required.

One type of zonal heater is:

In a central heating system, the thermostat should be placed:

A fitting with a removable plug is a:

A pipe, normally underground, that carries wastewater and refuse is a :

A pipe that carries the discharge of water closets or other similar fixtures is a:

Locating the water heater in an insulated space is one example of:

Another name for a water closet is:

Plumbing riser diagrams are usually drawn as an:

When indicating pipe elevation, the abbreviation "BOP" stands for:

Electrical installation for new construction occurs in what phases?

The abbreviation "AMP" stands for: (11-17)

A conduit is:

Maximum distance between wall plug is:

Each wall over ___ must have an outlet.

Keeping outlets to a minimum at exterior walls is considered:

Identify the HVAC symbol.

Identify the symbol.

Identify the symbol.

Identify the symbol.

Identify the symbol.

Some principle parts of a refrigeration system are:

The code that controls electrical circuits and plans is the:

Light switches would normally be placed ___ above the floor.

Identify the HVAC symbol.

Identify the HVAC symbol.

Identify the HVAC symbol.

Identify the symbol.

Identify the symbol.

Identify the symbol.

Identify the symbol. (11-36)

Heating and cooling equipment do not need to be accessible.

HVAC equipment located on the ground should be supported on a concrete slab.

Equipment connected to duct systems must have a temperature limit control.

HVAC equipment installed outdoors must be listed and labeled for outdoor use.

Ducts in unconditioned areas do not have to be insulated.

A heat pump is a forced-air central heating and cooling system.

A zonal heating system allows the heating of the home to family's needs.

A zonal heating system has only one thermostat for the house.

A central heating system requires using all the heat produced.

Industrial piping is used to carry liquids and gases used in the manufacture of products.

Residential piping is called plumbing.

Using a low-flow shower head is a good example of energy conservation.

The only plumbing items shown on the floor plan are fixtures.

There should be at least one ceiling outlet for every two cars in a garage.

Smoke detectors are required in all bedrooms rooms.