WorksheetsTires #2
Total questions: 19
Worksheet time: 46mins
The width of this tire is:
17 inches
225 cm
225 mm
50 mm
The second number in the tire size (50) is the:
Aspect Ratio
Diameter
Section Witdth
Temperature Rating
The speed rating for this tire is:
"R"
50 mph
Information not given in this picture
"H"
The "98" in the tire pictured indicates the:
Section width
Burnout potential
Load Index
Speed Rating
DOT stands for
Depth of Tread
Design of Tread
Dept of Transportation
Design of Tire
When was this tire manufactured?
4th month of 2008
4 week of August
29th week of 2010
Information not provided in this picture
The tire wear in the picture is caused by:
Excessive Toe
Excessive Camber
Excessive Caster
Incorrect Tire Pressure
2 techs are discussing TPMS. Tech A says that indirect TPMS sysems use sensors mounted in the wheels. Tech B says that vehicles may need to relearn sensor location after rotating tires. Who is correct?
Tech A
Tech B
Both Techs
Neither Tech
2 Techs are discussing mounting and balancing tires. Tech A says that the valve stem should be at 12 o'clock when installing tires. Tech B says that the valve stem should be at 5 o'clock when removing tires. Who is correct?
Tech A
Tech B
Both Techs
Neither Tech
This wear pattern is caused by:
Over inflation
Under inflation
Excessive Toe
Excessive Camber
The tool pictured is designed to do which of following?
Prevent wheels from getting scratched during removal
Prevent brake pads from getting damaged during removal
Limit lug nut torque when installing with an impact wrench
Bring color to the technician's tool collection
Which of the following statements are true of the tool pictured?
This tool is recommended from removing fasteners
This tool is used to apply a specific amount of torque to a fastener
This tool is very rugged and does NOT need to be handled with care.
Both A and B are correct
2 Techs are discussing tire pressure. Tech A says that tire pressure should be set to the tire pressure indicated on the side of the tire's sidewall. Tech B says tire pressure should be set to manufacturers specification based on the vehicle. Who is correct?
Tech A
Tech B
Both Techs
Neither Tech
2 techs are discussing tire pressure. Tech A says the specs can be found in the driver's door or jamb area. Tech B says that older vehicles may put a decal in the fuel door. Who is correct?
Tech A
Tech B
Both Techs
Neither Tech
Which of the following is true when changing tires?
A) The shovel should be kept away from TPMS sensors when breaking beads.
B) Beads should be lubed before removing tires.
C) Air should be removed BEFORE breaking beads
D) All of the above
E) Only B and C are correct
When the tire balancer keeps asking for more weights to be added this is called:
Chasing Weights
Road Force Balancing
Static Balancing
Dynamic Balancing
What type of tread design does this tire have?
Symmetrical
Asymmetrical
Directional
What type of tread design does this tire have?
Symmetrical
Asymmetrical
Directional
What type of tread design does this tire have?
Symmetrical
Asymmetrical
Directional
