Font size
WorksheetsFront Wheel Alignment Principles
Total questions: 25
Worksheet time: 14mins
Which angle does the picture represent?
Positive camber
Negative camber
Which angle does the picture represent?
Positive camber
Negative camber
Which angle does the picture represent?
Toe out
Toe in
Which angle does the picture represent?
Toe out
Toe in
Which angle does the picture represent?
Negative caster
Positive caster
Which angle does the picture represent?
Negative caster
Positive caster
How many minutes equals one degree?
100
50
60
1
Excessive negative camber will cause the tires to
Wear rapidly on the inner edges
Wear rapidly on the outer edges
Cause a feathered edge
Will give the vehicle better straight ahead stability
Excessive positive toe causes excessive
toe out
toe in
Which of these is a direct tire wear angle? (select all that apply)
Toe
Caster
Camber
The four reasons for an alignment are
maintenance, performance, standard, modified
standard, modified, corrective, collision
maintenance, corrective, modified, collision
maintenance, modified, standard, frame pulling
Camber roll is caused by which suspension angle?
Total toe
Front caster angle
Front camber angle
All of the above
How would positive toe affect vehicle handling?
The vehicle will feel as if it were "darting"
There would be no customer concern/change in driving feeling
The vehicle will feel as if it were "wandering"
Technician A says SAI is not adjustable. Technician B says IA is adjustable. Who is correct?
Technician A
Technician B
Both technicians
Neither technician
When describing turning angle/maximum steering angle,
The outer front wheel must turn at a sharper angle than the inner wheel.
Both front wheels turn at equal angles.
The inner front wheel must turn at a sharper angle than the outer wheel.
The degree the wheels turn vary depending on speed.
When discussing Macpherson strut type suspension systems, Technician A says that if your SAI is higher than specification, then you should check for damage towards the strut tower. Technician B says that if your IA angle is lower than specification you should check for damage at the steering knuckle. Who is correct?
Technician B
Technician B
Both technicians
Neither technician
Negative front toe will cause:
the tire's outer shoulders to wear.
rapid wear to the center section of the tire.
the tire's inner shoulders wear.
will not cause any irregular wear to the tire.
Technician A says a vehicle will drift or pull to the side with the most positive caster setting. Technician B says that caster is an indirect tire wear angle. Who is correct?
Technician A
Technician B
Both technicians
Neither technician
Name component ?
Spring
Shock
Strut
Bearing Plate
What part is this???
Inner Tie Rod
Connector Link
Steering End
Outer Tie Rod
What is this parts name??
Suspension Connector
Sway Bar
Inner Tie Rod
Sway Bar End Link
What is it?
Strut Rod
Inner Tie Rod
Steering Connector
Stabilizer Link
What are acceptable names for this component
Sway Bar Connectors
Stabilizer End Links
Strut Rod End Links
Sway Bar End Links
Which statement is true about springs?
Torsion bars are often adjustable to control ride height
Leaf springs use a center bolt
Spring can sag resulting in lower ride height
All of the above
When performing an alignment, a scan tool is likely to be needed to perform which operation?
Measure rear toe (total)
Calibrate steering angle sensor
Center the steering wheel
All of the above
