Cargoes that may ________ means cargoes which contain proportion of fine particles and a certain amount of moisture.

A type of clean on bulk carriers cargo hold requiring 100% intact paint coatings on all surfaces.

A type of clean of cargo hold means that holds are swept clean with no residue of the previous cargo.

What is logs which are slab cut.

Shifting of cargo is cause by a loose stowage improper securing and a small _________ due to high stowage on deck cargo.

All vessel are marked with ________ in addition to the normal load lines.

It is use to correct the upper casting of a top layer of container in stack.

It is non lockable inter layer stalker sometimes known as _____.

It is an item or commodities carried on the weather deck and or on hatch cover top of the ship.

It is use to secure cargo or commodities especially on container cargo.

It is defined which means that a timber cargo carried on uncovered part of a freeboard .

Regulation VII/5 and VII/6 of the 1974 SOLAS convention require cargo unit , transport, stowage,are secure throughout the voyage in accordance with the ________.

It is an act of installing a wood timber or structure so that extend from deck or bulkhead.

1. True or False. Hatch cover inspection covers a primary structural and watertight barrier to prevent water ingress into cargo holds.

True or False. Hatch cover inspection is to maintain sufficient strength to resist green seas landing on hatches on extreme weather.

True or False. The definition of water tightness states that water cannot enter the hold through the sealing tape.

TRUE or FALSE. Hatch cover inspection covers a primary structural and watertight barrier to prevent water ingress into cargo holds.

TRUE or FALSE. Hatch cover inspection is to maintain sufficient strenght to resist green seas landing on hatches on extreme weather.

True or False. The definition of water tightness states that water cannot enter or exit the hold through sealing tape.

True or False. The definition of weather tightness states that waters cannot enter or exit in the hold through sealing tape.

True or False. Hatch cover can be subjected to very low pressure loading during heavy weather.

True or False. Leakage can, if unchecked cause serious flooding and ultimately endanger the ship and its personnel.

True or False. A hatch cover constructed from high tensile steel will normally comprises thinner plating than one constructed from mild steel.

True or False. Renewing a worn rubber seal is all that keep a hatch cover water tight.

True or False. Screwing cleats up hard will ensure weathertightness of hatch cover.

Which is hatch cover on the display figure.

Which is hatch cover cleats on the display choices.

Chose the rubber packing on the display.

On the figure below chose the oil tank opening.

Find compression bar in the figure below.

Find the cargo valve on the display.

which is hatch cover pad on the figure below.

Hatch cleat assembly for hatch cover of a bulk carrier.

True or False. To maintain sufficient strength to resist green seas landing on hatch cover in extreme weather is hatch cover inspection.

True or False. When carrying a cargo on top of the hatch cover is not necessary to fasten hatch cover cleats.

True or False. Any rubber gasket can be used provided that gasket fits to the hatch cover channel.

True or False. Most leakage problem occur because of poor maintenance.

True or False. Corrosion does not reduced hatch cover strength only cracking can damage and reduce strength.

True or False. Hatch cover are designed to make steel to steel contact between a define parts of the hatch cover and coaming when closed.

True or False. In replacing damaged rubber packing the minimum length is 50 centimeter.

True or False. Hatch coaming non-return valve are not so essential feature of the hatch double drainage system.

True or False. When rubber packing is impressed of about 50 percent of its designed compression should be completely replaced.

True or False. The two most common leak detection test are the water hose test and ultrasonic test and chalk test gives only poor compression and potential leaks.