NEW
Font size
Worksheetsvehicle transmission and driveline units(a)
Total questions: 10
Worksheet time: 50mins
To disengage the clutch excessive force is required.what components should be checked first?
Pedal,drive shaft ,transmission mounts and the master/slave cylinder
Pedal mechanism ,clutch cable , release shaft m, master /slave cylinder and hose
Clutch pressure plate , driven plate,flywheel face and master /slave cylinder
Clutch driven plate ,input shaft splines, clutch cables, and master /slave cylinder
Which component provides the clamping pressure for the clutch shown in the image?
1
2
4
6
Which one of the following symptoms would a worm selector fork cause?
Jumping out of gear
Tranmssion judder
Side cover oil leak
Layshaft end float
What is used to check flywheel run out?
Micrometer
Set square
Vernier caliper
Dial test indicator
What could be damaged when a transmission unit is removed on some vehicles ?
Suspension dampers
Cylinder head
Front cross member\
Coolant pipes or connections
Which one of the following is a routine service task carried out on a hydraulically operated clutch mechanism?
Adjusting the slave cylinder position
Replacing the master cylinder seals
Checking the fluid level in the reservoir
Checking the condition of the flywheel face
Which component connects the rotating clutch to the release mechanism shown in the image?
7
6
4
3
A final drive has an input torque of 110Nm the pinion gear has 12 teeth and the crown wheel has 48 teeth.what will the output torque
30Nm
110Nm
440Nm
660Nm
What is one function of a clutch?
Prevent two gears being selected at the same time
Allow the driver to overrun the vehicle when travelling downhill
Provide a means of increasing engine power as engine speed increase
Control the torque transmitted from the engine to the engine to the transmission system
What is the main type of gear used in a synchromesh gearbox?
Hypoid
Spur
Conical
Helical
