NEW
Font size
Worksheetsvehicle transmission and driveline units(d)
Total questions: 10
Worksheet time: 50mins
Which one of the following should be used to finally tighten flywheel bolts?
An air wrench
An impact wrench
A torque wrench
A rachet wrench
What is illustrated in the image shown?
Reverse gear idler
Gearbox interlock device
Synchromesh selection unit
Differential drive unit
What is the most accurate equipment to check the flywheel face for warping prior to replacing a clutch?
Micrometer
vernier caliper
dial test indicator
feeler gauge and straight edge
What type of final drive crown wheel gear is shown in the image?
Spur
Helical
Hypoid
Planet
What component holds the selected gear in mesh?
Synchromesh hub
Detent mechanism
Selector fork
Interlock mechanism
which one of the following applies to a clutch opearating cylinder ?
it is sealed and never needs its fluid checking
it is attached to the clutch release bearing
it is attached to the clutch release bearing
it used air as operating medium
Where does the half shaft transmit drive from?
Differential sun gear to the wheel hub
Differential planet gear to the wheel hub
Pinion to the planet spindle and gear wheels
Propeller shaft to the gearbox universal joints
What is the main type of gear used in a constant mesh gearbox?
Bevel
Helical
Hypoid
Spur
which gear will be selected by the circle component in the image?
first gear
third gear
fifth gear
reverse gear
What does a differential allow when a vehicle is travelling round a corner?
Inner wheel to travel faster than the outer wheel
Inner and outer wheels to travel at the same rate
Wheels to automatically brake if speed is exceeded
Outer wheel to travel faster than the inner wheel
