Font size
WorksheetsSemester 1Final Quiz
Total questions: 25
Worksheet time: 18mins
What's the general rule for holding a saw handle?
Two hands
Three, one, thumb around the handle
Tight fist around the handle
Loose grip around the handle
What would you be using to mark out your right angles?
Ruler
Protractor
Set Square
Compass
How do you chisel when using the mallet?
Hands underneath the handle front on to piece.
Hands over the handle front on to piece.
Hands underneath, right angles to piece.
Hands over the handle, right angles to piece.
What is a hazard of using the drill press?
Entanglement
Crushing
Manual handling
Electrocution
What rules go with 2 point perspective drawing
Horizon
Front, side and top views
Vanishing points
Aligning the views
Vertical lines are parallel
Orthographic sketching is used in industry to create an accurate representation of an object using...
2 point perspective
Scaled dimensions
Front side and top views
Anodes and Cathodes
Dashed lines for hidden views
A resistor
Amplifies voltage
Reduces the need for cables
Splits voltages
Stores charge
The Anode is
The clear plastic top
The Longer leg
The shorter leg
The angle of the chisel at the tip
The (+) side of the battery is marked as...
(a)
Essential parts of the circuit are...
Capacitor, Inductor, Conductor, Power Source
Power Source, Control, Modulator, Ignition
Power Source, Control, Load, Conductor
Load, Adapter, Power Source, Shifter
Transistor, Resistor, Cable, Diode
The first cut of a Western style hand saw is in the (a) direction.
Ohm's law states:
Voltage = Current / Resistance
Current = Voltage x Resistance
Resistance = Current x Voltage
Voltage = Current x Resistance
Hazards of Soldering...
Crushing
Atmospheric
Burns
Chemical
Flying objects
A (a) circuit has components in a daisy chain one after the other, meaning they all share the voltage among them.
A (a) circuit has the components piggy back each other so they all share the total voltage and split the current between them.
Always do this with a chisel
Have the bevel down into the wood
Hold the work piece steady with your opposite hand
Keep your fingers behind the blade
Hold the handle when using the mallet
What fault is happening if the LED flickers when you move the wires?
Loose connections
Short circuit
Too much resistance
Incorrect wiring
The LED has a brown tinge to it...
It has faded in the sun and needs replacing
It is a heavy duty LED and will work fine
It is wired incorrectly and needs fixing
The LED has shorted out and needs replacing
Use the image above...
One LED won't turn on but the others do
The switch doesn't work
There is a short circuit
Too much solder
The diode is back to front
The total length of the wall is 2200mm, The door is 900mm and is 150mm off the corner. What is the length of the remaining wall?
(a)
The wall is 2400mm and the 1600mm window is centre of the wall. How much wall is either side of the window?
(a)
Safe work practices in the work shop...
Hair tied back
No music
Sitting on benches
No running or fooling around
Proper PPE to be worn for the specific job
The proper sequence of a circuit is...
Positive, Load, Switch, Negative
Load, Negative, Switch, Positive
Positive, Switch, Load, Negative
Negative, Load, Switch Positive
What is the Resistance in Ohms of the Globe if the Voltage across it is 9V and the Total Current is .20A or 20mA?
(a)
Who is Luke Skywalker's father?
(a)
