Font size
WorksheetsBasic 2D Sketching - Fusion 360
Total questions: 15
Worksheet time: 9mins
Which of these are found in the Sketch Toolbar? (check all that applies)
Trim
Offset
Circle
Polygon
Rectangle
Which part of the Fusion 360 UI allows you to draw your sketches?
View Cube
Application Bar
Canvass
Data Panel
Which of these constraints two lines so they lie at a 90-degree angle with each other
Perpendicular
Parallel
Symmetry
Tangent
Which of these best describes the Fix/Unfix constraint?
Constraints a single line, or two points, to lie on either vertical or horizontal axis, whichever is the closest to its original alignment
Locks the size and position of an object
Constraints two lines so they extend on the same direction without intersecting
Constraints a curve and another object so that they touch at one point, but never intersects
Which of these constraints a curve and another object so that they touch at one point, but never intersects
Coincident
Colinear
Concentric
Tangent
To which of these elements can Concentric constraint be applied? (check all that applies)
Curves
Lines
Arcs
Angled Lines
Circles
On what part of the Fusion 360 UI can you locate all your saved work?
Data Panel
Navigation Bar
View Cube
Canvass
Which of these shortcut key and tool pair is/are correct? (check all that applies)
O is for Offset
C is for Circle
T is for Trim
R is for Rectangle
S is for Slot
You can define how many sides a polygon will have. True or False?
True
False
Slots can be drawn at a certain angle. True or False?
True
False
Which part of the Fusion 360 UI can you change the default unit of measurement?
Data Panel
Application Bar
Browser
View Cube
Which of these is the default unit of measurement for Fusion 360?
in
mm
cm
ft
Which of these best describes Midpoint constraint? (check all that applies)
Constraints an object to be situated on the midpoint of another object
Represented by a triangle
Constraints two or more objects so that they are identical to each other in relation to a common axis
Constraints similar objects so that their sizes are similar
Can be applied with points and lines
Which of these constraints the position of two points or a point and a line together
Tangent
Coincident
Concentric
Fix/Unfix
Which of these tools can be located in Modify? (check all that applies)
Trim
Offset
Polygon
Fillet
Slot
