NEW
Font size
WorksheetsAg Mech II Obj. 3.02
Total questions: 19
Worksheet time: 10mins
When one uses the electric drill press to drill holes in flat or rectangular steel, the steel should be held in place by using:
Both hands
vise grip pliers
drill-press vise
machinist's vise
Which measuring tool is best to determine the space between two parts, such as piston ring gaps or valve gaps?
feeler gauge
flexible tape
wire gauge
dividers
A cold chisel is used to cut
ice
metal
plastic
wood
The minimum number of hacksaw teeth that should be cutting the metal at one time is:
1
3
6
8
When Sue is using a file, she should:
avoid applying any pressure
apply pressure on the back stroke
apply pressure on the forward stroke
apply pressure on both strokes
What is used to make a permanent mark on metal?
pencil
soapstone
chalk
awl
What is used to determine the size of a portable electric drill?
the largest straight-shank drill bit that can be inserted in the chuck
the longest length of bit that can be used in the drill
the most RPM the drill can produce
the horsepower rating of the drill
What tool is used to make a starting dent before drilling a hole in metal?
nail
nail set
pin punch
center punch
To make a square mark on a board, the handle of a square has to be held:
with the left hand
with the right hand
firmly against the board
loosely against the board
The best micrometer for measuring to the bottom of openings such as holes or slots is the:
depth micrometer
inside micrometer
outside micrometer
flexible micrometer
What type of drill is most accurate for drilling holes in cold metal?
battery powered drill
portable electric drill
cutting torch
electric drill press
If a board is marked correctly, sawing out the line will make the board:
too long
too short
too wide
the correct size
Eric uses oil while cutting threads on a metal rod to:
harden the threads
soften the threads
lubricate the die
clean the metal
What should be used to support machinery or equipment after it has been lifted to the desired height?
jacks
buckets
jack stands
wood blocks
To prevent a drill bit from binding, causing the stock to rotate or break the drill bit, what is done to the drill just before it breaks through the metal?
increase the RPM of the drill
decrease the RPM of the drill
increase the pressure of the drill
decrease the pressure of the drill
Using a file without a handle may result in:
fewer filings
hand injury
sharper file
proper file use
What hammer is used to hit a metal punch to drive objects?
Ball peen hammer
ripping hammer
chipping hammer
nail hammer
The thimble and barrel of a micrometer are marked with scales for:
calculating drag
measuring kilowatts
determining horsepower
making and reading measurements
When sawing with the hacksaw, one should:
avoid applying pressure
apply pressure on both strokes
apply pressure on the back stroke
apply pressure only on the forward stroke
