Font size
WorksheetsAES - Electrical System
Total questions: 15
Worksheet time: 14mins
All are T-41 ALTERNATOR specifications except?
28 Volts
38 ampere rating
Connected to the engine through accessory housing
Encased in an alloy housing
My specifications are:
- Lead Acid
- 12 Cell
- 24 Volts
- 17 Ampere-hour
- Quick Disconnect fitting
- Installed in the tail cone aft of baggage compartment
What am I?
(a)
Specifications:
- 28 Volt standard AN type receptacle
- Use for cold weather starting or when lengthy electrical maintenance.
- With reverse polarity protection
What am I?
(a)
I am the primary source of electrical power. What am I?
(a)
Specifications:
- Located at the upper right of the firewall
- Solid-state
- Remove and replace item
- Not repairable
- Regulates the alternator field current
What am I?
(a)
Specifications:
- Located at the firewall
- Remove and replace item
- Non-repairable
- Open the over voltage warning light when the voltage reading is 32 Volts and simultaneously shuts off the alternator.
What am I?
(a)
Specifications:
Press to test light Located on the lower right side of the instrument panel Illuminate anytime electrical system voltage exceeds approximately 32 volts.
What am I?
(a)
Specifications:
- Toggle type switch
- Located beside the throttle control lever
- Installed with a switch guard
- The function is to apply or remove power to the alternator field circuit
What am I?
(a)
Specifications:
- Located on the right side of the instrument panel
- Indicates a charging or discharging condition
- Also indicates the flow of electricity, in amperes, from the alternator to the battery or from the battery to the aircraft electrical system.
What am I?
(a)
Tick the battery system components.
Battery
Battery Contactor
Master Switch
Circuit Breakers and Fuses
Alternator
Specifications:
- Mounted beside the battery box
- Plunger type contactor
- Actuated by the Master Switch
What am I?
(a)
Specifications:
- Located on the lower switch and control panel
- Push-Pull type
- Pulled-On
- Pushed-Off
What am I?
(a)
Specifications:
- Mounted on the lower switch and control panel
- Labeled according to their funcion and aperage
- Push to reset type
- Must cool before it can be reset
- If the breaker trips after reset, do not attempt to reset again.
What am I?
(a)
Tick all ALTERNATING SYSTEM COMPONENTS.
Ammeter
Voltage Regulator
Over Voltage Relay
Over Warning Voltage Warning Light
Alternator Switch
All are electrical power source EXCEPT?
Alternator
Battery
External Power
Solenoid
