Wayground logo

Free Printable Worksheets

Font size

S
M
L
XL
Worksheets

Table Saw Safety

Total questions: 10

Worksheet time: 5mins

Name
Class
Date
1.

All students must be checked out on the table saw: *

a)

at the beginning of each semester

b)

only if you are in the Intro to Woodworking class

c)

only if you haven’t used it before

d)

every time you use it

2.

A push stick must be used when you are: *

a)

ripping narrow (less than 6” wide) pieces

b)

adjusting the saw

c)

turning on the saw

d)

crosscutting with a sled

3.

Freehand cutting without the aid of the fence or crosscut guide is: *

a)

permitted when stock is too large for the table

b)

okay if permission is received from the instructor

c)

never permitted because of the danger

d)

permitted if the operator has help

4.

The shortest piece you may rip cut without special permission is: *

a)

6"

b)

8 "

c)

10"

d)

12"

5.

You must never back the wood away from the blade: *

a)

without first rolling up your sleeves

b)

while the saw is running, due to the danger of a kickback

c)

without giving a signal

d)

except when sawdust or scraps are on the table

6.

If you are in the middle of a cut and the workpiece gets stuck: *

a)

If you are in the middle of a cut and the workpiece gets stuck: *

b)

back the piece out and try again

c)

force it

d)

turn off the saw by gently bumping the red Start/Stop paddle with your knee

7.

Reaching over the saw blade or passing wood over the saw blade when it is running: *

a)

speeds up the operation

b)

is dangerous and forbidden

c)

shows you are handy with machines

d)

lets you feed wood into the saw faster

8.

When “tailing off” the helper must remember to: *

1 point

a)

pick up scraps off the floor as the operator starts the cut

b)

hold the stock and pull it gently away from the saw once the operator starts the cut

c)

support the stock from underneath, but not grasp it

d)

pull the stock faster if the operator is too slow

9.

When ripping stock, you should push the piece that is against the fence clear of the saw blade and onto the outfeed table. Failure to do so may result in: *

a)

damage to the blade.

b)

pinching the board.

c)

a kickback.

d)

None of the above.

10.

At the end of a rip cut, your left hand should be: *

1 point

a)

on your head

b)

holding on to the offcut.

c)

resting on the table.

d)

off the table.