WorksheetsIntro to Auto Quiz 3
Total questions: 24
Worksheet time: 12mins
Which is the correct lubricant for the front axle on a rear-wheel-drive car?
motor oil
transmission fluid
white lithium grease
wheel bearing grease
Technician A says it is acceptable to use brake cleaner to clean throttle
bodies. Technician B says it is acceptable to mix DOT 5 brake fluid with
DOT 3 brake fluid. Who is right?
A only
B only
Both A and B
Neither A nor B
Where should cleaning chemicals be stored in the auto shop?
file cabinet
. fire-retardant cabinet
instructor's office
toolbox side tray
Intro
Where should micrometers be stored while not being used?
in a wooden or plastic box
under a tool box
. in the broom closet
. in the bolt cabinet
Which type of socket will best hold a nut and/or bolt?
2 point
6 point
8 point
12 point
What color are impact sockets?
blue
chrome
gray
. black
Where on a vehicle should a VIN be found?
driver's door frame
engine block
operator's manual
service manual
What should be done to air tools daily to keep them in good working
condition?
Disassemble them.
Oil them.
Wash them.
Grease them.
Which tool should be used to remove an oil filter?
oil filter clamp
oil filter press
oil filter screwdriver
oil filter wrench
Which tool would be used along with a hammer to cut a rounded-off nut
on a vehicle?
chisel
file
punch
screwdriver
What is the most common type of hammer used in an automotive shop?
ball peen
dead blow
impact
sledge
When a tool breaks, what should be done?
Do nothing; keep using it.
Return it to its proper location
Tag it, and report it.
Throw it away.
What are the three C's associated with a work order?
concern, cause, coordinate
concern, cause, correction
cause, correction, cost
cause, cost, coordinate
What tool would be used to measure the thickness of a solid metal rod?
depth gauge
dial indicator
inside micrometer
outside micrometer
Why would a technician not use the open end of a wrench to untighten a
frozen nut or bolt on a vehicle?
loosens too easily
rounds the fastener
breaks the fastener
strips the threads
To prevent damage to the vehicle's paint, what safety precaution should
a technician take before working on an engine?
install a hood prop
install fender covers
remove the air cleaner
remove the hood
Which tool would most likely be used to remove a brake line?
box-end wrench
open-end wrench
pipe wrench
tubing wrench
Which tool is used to remove snap rings?
snap ring compressor
snap ring pliers
snap ring ratchet
snap ring spreader
What information is normally excluded from a work order?
cause of vehicle's problem
customer information
previous owner's problem
vehicle information
Intro
While road testing a vehicle, a technician verifies the customer's
complaint of steering wheel shimmy during hard braking. What should
the technician do next?
note the concern on the repair order
order parts
tell the service consultant about the concern
tell the shop foreman
While working in the engine compartment, what is used to protect the
painted surfaces from being scratched by a technician's belt?
blanket cover
paper cover
carpet cover
fender cover
Before starting work on any vehicle, it's important to:
check with the sales manager.
check with the parts manager.
gather as much information as you can.
raise the vehicle on the lift.
What document should a technician use to research vehicles of the same
year, make, and model having similar problems?
EPA
OSHA
SDS
TSB
I will study these questions so I can pass my exam?
Yes
No
Maybe
