Journal bearings are designed to be used for _______________ loads.

Plain _____________ bearings are used only where axial loads are present.

Plain bearings are divided into two general categories: Solid bearings and ________________ bearings.

A Bushing is another name for a plain journal bearing.

______________ is used where full-film lubrication is not possible.

Oil can lubrication is used to apply oil directly on the components or into a(n) __________________

In a pressure feed system, oil is pumped from a(n) __________________.

The _____________ lubrication system requires a great deal of space.

In a type 1 plain bearing (bronze), the term "Type 1" refers to the oil ___________ inside the bearing.

Fatigue resistance is the ability of the bearing material to withstand repeated application of _______________.

Embeddability is the ability of the bearing lining material to _____________ slight dirt particles.

_______________________ is a relatively soft material.

______________________ bearings are constructed from fine metal particles.

The load carrying ability of a plain bearing material can be expressed as a(n) _________________________.

A hot bearing is usually a sign of a bearing in ____________________.

A noise in a plain bearing is usually a sign that the bearing is about to ________________.

A common source of vibration in a plain bearing is a bent _____________________.

Plain bearings can accept ___________________ misalignment.

A(n) __________________ is a type of bearing system fault.

Plain bearing maintenance includes checking for dirt, the best solution is usually to remove the source of the dirt or _____________________. (Page 51)

Sintered bronze bearings require ___________________. (Page 15)

When selecting a plain bearing lubrication system, a general rule of thumb is heavier oils or grease are recommended for _________________________. (Page 25)

The purpose of the groove in a Type 1 bearing is to ____________________. (Page 13)

Shaft clearance in a plain bearing installation is the ____________________. (Page 46)

The three types of plain bearings used in industry today are: _______________, ______________, and ____________________. (Page 5)

Babbitt is an alloy of ___________. (Page 34)

When inspecting and troubleshooting a plain bearing system it is best to use an aid such as a table that lists faults and probable causes plus _____________________. (Page 54)

The best way to install a plain bearing in a bearing housing is using ________________.(Page 16)

When selecting a plain bearing for a given installation, the first step is to calculate the _____________ factor. (Page 37)

The four basic components of a plain bearing assembly are: bearing, bearing housing, ________________, and lubricant. (Page 9)

The PV factor in a plain bearing material is an indication of its ___________________.(Page 37)

A bearing is a device that reduces __________________ between two surfaces while supporting a load. (Page 8)

When specifying plain bearings there are typically four features described: the manufacturers code, bore, outside diameter, and ______________________. (Page 28)