NEW
Font size
WorksheetsSAMTK Day 2
Total questions: 15
Worksheet time: 8mins
Which of the following statements correctly describes the function of a radiator cap?
Valves inside the radiator cap regulate the pressure in the cooling system, thereby preventing damage to the system’s pipes and other components.
A filter inside the radiator cap prevents rust and other foreign substances in the coolant from entering the radiator core.
The radiator cap is triple-sealed to keep the cooling system completely airtight.
A temperature sensor in the radiator cap sends coolant temperature signals to the PGM-FI unit.
Which of the following statements correctly describes the flow of coolant immediately after a cold engine is started?
The coolant circulates through the radiator and cylinder block.
Until the engine warms up, the coolant circulates through the
water jacket but does not flow into the radiator.
No coolant circulation takes place until the engine has warmed up.
The coolant is circulated only through the radiator.
Which one of the following components is responsible for converting
the rotation of the steering wheel into lateral motion?
Steering wheel
Steering shaft
Steering gearbox
Tie rod
Power Steering System is designed for
effort to turn the steering wheel can be reduced when driving at low speed and parking
effort to turn the steering wheel can be increased when driving at high speed
effort to turn the steering wheel can be reduced when driving at high speed
effort to turn the steering wheel can be increased when driving at low speed and parking
Which one is the function of suspension?
To ensure the wheels are always firmly in contact with the road surface.
To ensure that the steering wheel can deliver a suitable amount of steering force.
To ensure that wheel alignment is not disturbed during driving.
To automatically correct effects of over-steering.
In what case is the use of rigid suspension beneficial?
When it is desired to reduce the unsprung mass.
When it is desired to improve tire-to-ground contact characteristics.
When it is desired to have more flexibility in design.
When large changes in load make it necessary to have a large suspension stroke.
What is the main function of torque converter?
To transfer the engine’s output power to the gear unit through the action of a special fluid.
To enable a transmission efficiency of 100% to be achieved.
To control the hydraulic pressure.
To enable shifting of gears within the range selected by the driver, performed automatically.
What is the result of an increase in the Drive Pulley diameter and
a decrease in the Driven Pulley diameter?
High gear ratio
Low gear ratio
No effect
Middle gear ratio
Where is the manufacturing plant of Honda Access wheel lock nut?
USA
Japan
Malaysia
Thailand
Service Advisor needs to advise the customer on changing tires when it reaches mm?
1.6 mm
2.0 mm
2.5 mm
4.5 mm
Can Honda Access instant tyre repair kit seal tyre sidewall damage? How big damage/hole can the Honda Access Instant Tyre Repair Kit seal?
No. 4mm
No. 6mm
Yes. 1mm
Yes. 10mm
What is the filtration efficiency of the Honda Access charcoal filter (grey) vs Honda Genuine filter (white)?
0.3 micron vs 1 micron
30 micron vs 1 micron
10 micron vs 30 micron
1 micro vs 10 micron
Which will be the incorrect symptom if the ATF is not replaced on schedule?
Poor gear changes
Poor acceleration
Engine overheating
Increase gear shock
Choose 2 types of power steering system used by Honda:
I) Hydraulic Power Steering System
II) Vehicle Stability Assist (VSA)
III) Pneumatic Power Steering (PPS)
IV) Electronic Power Steering (EPS)
I & II
II & III
III & IV
I & IV
CVT Fluid is design to;
prolong the life of the battery
prevent wear of the Steel Belt and between the pulleys.
prevent vibration of the engine
make the engine temperature cooler
