NEW
Font size
WorksheetsSteering 6
Total questions: 10
Worksheet time: 6mins
What is equipment pictured?
Dunlop Tracking Gauge
Laser wheel aligner
Analog tracking gauge
Camber gauge
What type of loads are exerted on wheel bearings
Axial and Radial
Axle and Radial
Axial and Radii
Axle and Radius
Because of there long fine needle rollers, these bearings can support heavy loads?
True
False
Taper roller bearings are used in pairs mounted:
Tapers opposing, larger bearing inside.
Tapers opposing , larger bearing outside
Tapers Facing out, larger bearing inside.
Tapers facing in, larger bearing outside.
Why are plain bearings most common?
Very low friction
Very high friction
Only require one race
Do not require any lubrication
Where the axle is supported on it's inner end by a roller bearing, and a taper bearing inside the housing. This is known as a:
Semi-floating axle shaft
Half axle
Three quarter axle
Non-driven axle
Where two taper roller bearings are used between each hub and axle. This is known as?
Full floating axle shaft
Semi-floating axle
Semi-trailing axle
Full trailing axle
What bearing type is shown in picture?
Taper roller
Roller
Needle
Ball bearing
What type of hub si pictured?
Non-driven
Driven
Semi- floating
Half floating
What type of hub is pictured?
Driven
Non-driven
Fully dependent
Rear stub axle
