NEW
Font size
WorksheetsOverseeing 7
Total questions: 20
Worksheet time: 40mins
The information provided throughout the project must be clear, concise and:
electronic
manufacturers instructions
accurate
written
PPE should only be used where:
it is convenient to do so
The HSE specifies it
there is no other alternative
it makes the job quicker
Requests to carry out additional work on site are notified by a:
job sheet
purchase order
variation order
time sheet
The information provided to the client must include the requirements for:
design and installation
installation and control
maintenance and design
operation and maintenance
The deliveries of materials to a busy site must be:
ad-hoc
early in the morning
during break periods
coordinated
A PIR detector is used to sense
movement
light
temperature rise
temperature fall
The details of how to set up the limit switches on water storage vessel will be found in the manufactures:
brochure
catalogue
Instructions
specification
To confirm the health and safety requirements on site continue to be met it is necessary to carry out regular site inspections. These inspections would not include:
hand tools
work areas
access routes
working platforms
The person or organisation which employs your company to carry out the work is the:
designer
contractor
architect
client
A drawing at a scale of 1:200 shows a cable length of 150 mm, the actual length of the cable on site will be:
50 m
15 m
30 m
45 m
The preferred electrical supply for hand tools on a construction site is:
extra low voltage
reduced low voltage
high voltage
low voltage
Details of the progress and any delays on site will normally be discussed by regular:
emails
site meetings
site memos
telephone calls
The electrical installation certificate for an installation should be kept for the lifetime of the electrical installation. This should be kept by the:
consultant
architect
client
electrical contractor
The length of the installed underground cable supplying a detached garage some distance from a house is to be measured. The most appropriate tool to use for this task is a:
scale rule
3 m steel tape
laser measure
measuring wheel
Method statements for everyday activities are often included in the:
manufacturers information
electricians employment contract
company health and safety manual
project specification
Before any new work on site begins it is important to carry out a:
method statement
risk assessment
contract review
cost assessment
On completion of an electrical installation one item of information to be provided to the client would be:
the layout drawings
a set of wiring diagrams
the electrical installation certificate
the specification
The figure above is a:
wiring diagram
circuit diagram
layout drawing
block diagram
A main contractor has engaged an electrical contractor to carry out the electrical installation on a project. The relationship of the electrical contractor to the main contractor is as a:
management contractor
sub contractor
employee
consultant
Before an operative or visitor is allowed onto the site they may need to undergo:
a medical
induction training
a hearing test
a risk assessment
