What two inputs are typically found in the input section?

A low level signal that has to be amplified quite alot

The LED's on the this portion picture what? They are helpful to check and monitor the signals level so that you can easily spot clipping or signals that are possibly too soft.

What kind of power do you need for condenser mics or powered dynamic mics?

How many Volts is Phantom Power

What switch changes the input circuitry from the mic input to the instrument input

The switch that attenuates the signal down. This can be helpful when dealing with very loud sounds. usually attenuates signal down -10dB or -20dB

This switch inverts the signal phase-angle 180 degrees. This could prevent phase problems and cancellation.

This switch allows you to toggle between the mic signal and the line signal in the channel, and allows the line level output to be controlled with the channels fader.

Allows the high frequencies to pass, and cuts out the low frequencies

Point that allows you to insert a outboard processor into your channel

From what section of the console can you send a portion of the signal to an Aux Bus?

What section of the channel strip is this?

Knob that blends signal between the left and right output

Here we can select the channels output routing. we can send it to the master bus or to a group bus.

This fader controls the level of the master bus

For a recording setup, this is where you will take the signal from each channel to go into your audio interface (audio recorder)

This allows you to easily connect all the different channels in the studio

How the signal gets from the microphone to the speaker