WorksheetsActivity Test in CSS 9
Total questions: 20
Worksheet time: 10mins
A type of troubleshooting techniques for the network system where in home network setup several computers and devices, it is ideal to assign each of them a specific
address.
Adapter functionality
Assigning a Dynamic IP Address
Verify connections / LEDs
Adapter resources
A type of troubleshooting techniques for the network system that the network card is capable of detecting or seeing itself by using the ping command.
Adapter functionality
Assigning a Dynamic IP Address
Verify connections / LEDs
Assigning a static IP Address
A type of troubleshooting techniques for the network system you should verify that the network cable is properly connected to the back of the computer. Neighborhood to refresh the network connections and possibly detect the network.
Adapter functionality
Assigning a Dynamic IP Address
Verify connections / LEDs
Assigning a static IP Address
A type of troubleshooting techniques for the network system that the card does not have any lights or has orange or red lights, it is possible that either the card is bad, the card is not connected properly, or that the card is not receiving a signal from the network.
Adapter functionality
Assigning a Dynamic IP Address
Verify connections / LEDs
Assigning a static IP Address
If your computer cannot communicate with the DHCP server to obtain an IP address, the Windows operating system automatically assigns a private IP address.
Adapter functionality
Assigning a Dynamic IP Address
Verify connections / LEDs
Assigning a static IP Address
A number that is used to identify a device on the network.
LAN
IP Address
Subnet Mask
IPS2
It indicates the network portion of an IP address.
LAN
IP Address
Subnet Mask
IPS2
What is the first step in connecting cables?
Connect an Ethernet cable from your modem to the wireless router (there is usually a short Ethernet cable included with your wireless router for this purpose).
Once you’ve acquired a wireless router, you’ll need to connect it to your existing internet modem.
Plug in the power cable for the wireless router.
Wait at least 30 to 60 seconds, and make sure the lights on your router are working correctly.
What is the last step in connecting cables?
Connect an Ethernet cable from your modem to the wireless router (there is usually a short Ethernet cable included with your wireless router for this purpose).
Once you’ve acquired a wireless router, you’ll need to connect it to your existing internet modem
Plug in the power cable for the wireless router.
Wait at least 30 to 60 seconds, and make sure the lights on your router are working correctly.
What is the 3rd step in viewing Wireless Network Connection Status Details?
Click Open and Network Sharing Center
Right Click Network and Sharing Icon in your taskbar. Then Click Open and Network Sharing Center
Right Click the wifi name. Click Status
To configure security settings, click Wireless Properties
CAT5 Ethernet cables should not run longer than 350 feet.
TRUE
FALSE
Uses a central device router with cables extending in all directions.
TRUE
FALSE
Uses one short cable, referred to as backbone, to which computers and other devices are attached.
TRUE
FALSE
WAN connection is required when you want to share your pc with others in your Home Group.
TRUE
FALSE
Routers and network adapters are typically created in WEP for Home and small-business users.
TRUE
FALSE
A terminator is placed at each end of the backbone to keep the signals from bouncing back and being received again by the nodes in the network.
TRUE
FALSE
Any data or messages will pass through adjacent nodes until it reaches the target node.
TRUE
FALSE
(WPA) protocol provides for increased security over that of the WEP standard.
TRUE
FALSE
802.11a, 802.11b, 802.11g, and 802.11n are the most commonly used wireless standards.
TRUE
FALSE
Using a Dynamic Host Configuration Protocol (DHCP) server would automatically assign IP addresses and greatly simplify the addressing process.
TRUE
FALSE
