WorksheetsPower Tools
Total questions: 30
Worksheet time: 3600secs
Pneumatic tools are powered by air.
True
False
Hydraulic tools are powered by ___________.
air pressure
gasoline
electricity
fluid pressure
You should always disconnect the power source before changing, bits, blades, or performing maintenance or service on a power tool.
True
False
It is not important to wear the correct PPE when working with power tools.
True
False
Power drills are commonly used to make holes by spinning drill bits into wood, plastic, metal, concrete, or stone.
True
False
The part of the drill that holds the bit is called the _______.
Trigger
Key
Chuck
Handle
Saws with fine blades that are excellent for delicate and intricate cutting are called....
band saws
saber saws
abrasive saws
worm-drive saws
When using a circular saw, be sure to cut on the waste side of the cut mark to allow for blade's....
arbor
kerf
distortion
stroke
A pneumatic drill is commonly used...
in areas where noise is a problem
to supply compressed air to de-burr pipes
where there is no source of electricity
for intricate detail work
Before replacing parts such as bits, blades, or discs on any tool, you must....
polish it with a fine steel wool
recharge the tool's battery
disconnect the power source
inspect them for cracks
When using power tools, never engage the....
locking spring
booster
bit shank
trigger lock
A good way to check the condition of the grinding wheel on a bench grinder is to....
exceed the maximum rpm rating
hold the tool rest against the wheel
induce vibration and monitor the wheel's response
perform a ring test on the wheel
The adjustable tool rest on the bench grinder should be positioned...
1/8 inch from the grinding wheel
1/4 inch from the upper wheel guard
1/2 inch from the lower guard
3/4 inch from the wheeel arbor
And angle grinder is used to grind...
soft, porous materials
imperfections in wood
hard, heavy materials
nonmetals only
A power miter saw combines a miter box with a...
bandsaw
circular saw
reciprocating saw
saber saw
A porta-power is an example of...
electric tool
pneumatic tool
hydraulic tool
battery-powered tool
A power tool that is well suited for breaking up concrete during demolition work is a ....
saber saw
impact wrench
pavement breaker
powder actuator
The reciprocating saw is used for heavy duty demolition jobs.
true
false
To cut a flat bottomed circular hole with no marks left in the center of the whole, you would use a _____________ bit.
spade
paddle
forstner
twist
The amount of material removed by a saw that becomes sawdust when cutting is called ______.
kerf
space
extra
dissolve
Before plugging any tool into its power source, make sure _______.
it is fully charged
that the power switch is in the on position
that the power switch is in the off position
that there are witnesses
A saw that has a thin, one-piece blade that runs around guides at either end of the saw is a...
miter saw
bandsaw
saber saw
circular saw
A grinder can catch on rough material and shift around, especially when using rotary bits called .....
burr bits
backing bits
kerf bits
saber bits
Name this power tool
miter saw
circular saw
skill saw
table saw
Name this power tool
miter saw
table saw
circular saw
round saw
Name this power tool
reciprocating saw (sawzall)
jig saw
circular saw
miter saw
What tool do these blades fit?
Jig saw
Reciprocating saw
Miter saw
Circular Saw
Name this power tool
Cordless drill
Impact driver
Screw driver
Jig Saw
Name this power tool
Jack hammer
Cordless drill
Hammer drill
Impact driver
The more teeth on a saw blade...
the faster and rougher the cut will be.
the slower and smoother the cut will be.
make little to no difference in the cut.
the softer and less dense the material being cut can be.
