WorksheetsCotter and Knuckle Joints
Total questions: 9
Worksheet time: 10mins
Cotter joint is used when the members are subjected to which type of stresses?
Axial tensile
Bending load
Axial tensile or compressive
Torsional load
In a gib and cotter joint, the gib and cotter are subjected to
single shear only
double shear and crushing
single shear and crushing
double shear only
A cotter joint is to support a load varying from 30 kN in compression to 30 kN in tension. The load is applied statically with Tensile stress = compressive stress = 50 MPa ; shear stress = 35 MPa and crushing stress = 90 MPa.Find Diameter of the rods.
Which of the following are important parts of knuckle joint?
Eye
Pin
Fork
Each of the mentioned
Calculate the diameter of pin in a knuckle joint from shear consideration with maximum shear stress allowed is 40N/mm² and an axial tensile force of 50kN is acting on the rod.
39mm
44mm
49mm
101 mm
Identify the joint shown in the picture
Gib and cotter joint
Socket and spigot joint
Knuckle joint
sleeve joint
Identify the joint shown
Socket and spigot joint
Gib and cotter joint
Knuckle joint
sleeve and cotter joint
Identify the joint shown
Socket and spigot joint
Gib and cotter joint
knuckle joint
sleeve joint
A Knuckle joint is to support a load varying from 30 kN in compression to 30 kN in tension. The load is applied statically with Tensile stress = compressive stress = 50 MPa ; shear stress = 35 MPa and crushing stress = 90 MPa. Find the thickness of eye end
