WorksheetsFitter technical
Total questions: 11
Worksheet time: 6mins
1. Forging is done at?
The melting point of the metal
Below the melting of the metal
Above the melting point of the metal
None of the above
Which among the following tools is used for flattening the metal around punched hole
Ball pein Hammer
Sledge Hammer
Rivetting Hammer
Cross pein Hammer
Straight peen hammer should peen?
Angular
Straight
Cross
Bent toward
In a single start thread?
Lead and pitch are equal
lead is double the pitch.
pitch is double the lead
Lead is half the pitch
. Which is not a part of combination set
Stock
protractor head
Square head
Centre head
Which type of fire extinguisher is used in welding shop
foam type
CTC type
Dry type
CO2 type
Try square is used to check up an angle of
30
60
90
108
Steel rule minimum measurement is
0.25mm
0.50 mm
0.01 mm
0.05 mm
Which of the following is a direct measuring tool
tri square
steel rule
caliper
ring guage
Which of the following is a direct measuring tool
zinc
brass
stainless steel
cast iron
The base unit of length as per S.I. units is
meter
centimetre
foot
inch
