WorksheetsLIMIT FIT & TOLERANCE
Total questions: 10
Worksheet time: 5mins
Any part selected at random should assemble correctly, When a system of this kind is ensured, it is called________
Interchangeable system
Systematic error
Random error
Non systematic error
It is ____ to produce a component to an absolute or 100% dimensional accuracy
Possible
Impossible
Static
Dynamic
Therefore depending upon the functional requirements of a work, some variation is permitted in the size of the part is called as____
Tolerance
Fit
Clearance
None of the above
________ a system of standard tolerances & deviations
Limits
Fits
Limit system
Tolerance
______ is a number expressed in a particular unit in the measurement of length, width, etc.
Limits
Fits
Size
Tolerance
_______is the size of dimension, its specified in the drawing. It is used for identification.
Limit size
Nominal size
Basic size
Actual size
____is the size of dimension, in relation to which all limits of variations are determined
Basic size
Nominal size
Limit size
None of the above
The measured size is also known as ____
Basic size
Nominal size
Actual size
Limit size
______ are the two extreme permissible sizes for that dimension, there being an upper limit & a lower limit.
Basic size
Limit of size
Nominal size
Actual size
The upper limit is the ____ & lower limit is the _____ permissible sizes
smallest
largest
largest & smallest
None of the above
