Font size
WorksheetsTools & Safety
Total questions: 20
Worksheet time: 28mins
What kind of driver is this?
flat
allen
phillips
forstner
hex
What is this tool used for?
to tighten down a chock that is holding a bit
to open up the drill press to set the belt speed
to turn a large gear screw
to unlock and replace a blade on a circular saw
When using a drill press, what should be done to the object that you are drilling into?
hold it loosely in case the drill pulls on it
hold it close to prevent it from rotating
use a vise or clamp to secure it
place oil on the wood
what is this tool?
phillips head
robertson head
allen key
spade bit
Ikea key
What type of bit is this and what is its purpose?
Spade bit, to make smooth finished holes through wood.
Spade bit, to make rough openings in wood.
Forstner bit, to make rough openings in wood.
Forstner bit, to make smooth finished holes through wood.
Router bit, to decorate the edge of the wood.
What is the pictured tool?
crescent wrench
Vise Grips/locking pliers
needle nose pliers
socket wrench
open ended wrench
What is the pictured tool?
needle nose pliers
metal snips
crescent wrench
wire strippers
dremel
Which of the following is a wood screw?
If wood is too hard or too hard to align later and it makes it difficult to be able to get a screw in, you should do this first.
use an awl to punch a beginning hole
use a smaller screw
make a pilot hole
use a machine screw
which of the following is a bolt?
Which of the following is a rip cut?
neither
What is the gap created by a saw blade called?
hack
board face
counter sink
kerf
What must be worn at all times to prevent flying debris and corrosive materials from getting in your eyes?
safety goggles or safety glasses
helmet
hair ties
contact lenses or prescription glasses
What items can get caught in moving parts and should not be worn while working in the lab part of the MakerSpace classroom?
jewelry
loose hair
scarves
long and loose clothing
all of the above
What type of shoes are allowed in the MakerSpace build lab?
flip flops
Birkenstocks
high heels
closed toe, non slip shoes
Before you turn on the drill press, select all the following that should be done:
remove the chock key from the chock to prevent it from spinning and binding
make sure you have secured with vise or clamp the object being drilled
make sure you have adjusted the height of the drill press
make sure the drill bit is secure and straight
make sure another student is standing in your yellow boxed work space to tell you what to do
When can you pick up and use a specific power tool in the MakerSpace. Select all that must be met.
after you have watched and understood that tool's use and safety video
after you have verbal permission from your instructor
after you are comfortable and in an alert state of mind
after you thought about and prepared for you cut or hole
just before class ends so you can finish your project
When should you report an injury that happened during class.
immediately
after class
when it gets infected
never so I don't get in trouble
Which drill bit should you use to make a pilot hole for the screw shown?
A
B
C
D
E
If you are not sure about your next cut or drill or how to use a piece of equipment, which of the following should you do?
read the project instructions again
rewatch a specific equipment video
ask your instructor
just give it a try so you don't waste time
