NEW
Font size
WorksheetsGetting familiar with EV3
Total questions: 11
Worksheet time: 6mins
Which of the following CANNOT be used for providing power to the EV3
6 AA batteries
6 AAA batteries
Ev3 rechargable DC battery
The ev3 accepts any of the listed sources
What is Firmware?
A special type of software that allows the EV3 to understand the programs you write
A special type of software used by law firms
The parts of the robot that are not flexible
The physical appearance of the robot
How do you turn on the EV3
Left Button
Right Button
Center Button
Top Button
Motor (output) ports are identified using ____
Numbers 1, 2, 3, 4
Letters A, B, C, D
Numerals I, II, III, IV
USB and PC Ports
Sensor (Input) ports are identified using ____
Numbers 1, 2, 3, 4
Letters A, B, C, D
Numerals I, II, III, IV
USB and PC Ports
How do you turn off the EV3 properly?
Remove the rechargable battery
Press and hold the Left and Right Buttons for 5 seconds
Press the Back button until a Shut Down dialog appears, then select the checkbox with the center button
Insert the Sut Down USB adapter into the USB port on the side of the EV3
How do you navigate the menus of the EV3
Touch the screen with an included stylus pen
Use the lego IR remote
Use the direction buttons to navigate, Center button to select, back button to cancel or go back
Use the Sound sensor and the built-it voice commands
To run a program from the Run Recent menu, what do you do?
Run Recent (first tab) > Select the program then press the center button
File Navigation (second tab) > Select the Project > Select the Program
Brick Apps (third tab) > Port View > Select the motor or sensor that you just recently used to run that program
Settings (fourth tab) > Brick Info > Recently Run, then use the center button to select
To run a program from the File Navigation menu, what do you do?
Run Recent (first tab) > Select the program then press the center button
File Navigation (second tab) > Select the Project > Select the Program
Brick Apps (third tab) > Port View > Select the motor or sensor that you just recently used to run that program
Settings (fourth tab) > Brick Info > Recently Run, then use the center button to select
How do you check the motor and sensor values on the EV3?
Plugging the EV3 into the computer and using the EV3 Software to check
Using the Brick Apps (third menu) > Port View > Select the motor or sensor you want to view
Adding a block to display the motor/sensor value when running a program
Attaching a second screen adapter to the USB Port on the side of the EV3
Where can you find the speaker volume and other settings on the EV3?
On the back of the EV3
In the Settings (fourth tab) menu
Behind the battery pack
On the EV3 Software
