NEW
Font size
WorksheetsTest - FT Heritage - Advance Service Training
Total questions: 12
Worksheet time: 12mins
Valve Clearance value for Inlet & Exhaust valve of FT 6050 Engine is
0.30 mm & 0.40 mm
0.20 mm & 0.30 mm
0.40 mm & 0.60 mm
0.80 mm & 1.00 mm
To set the FIP Timing in FT 6050 Engine
Insert the pin in 1st Hole of Flyweel
Insert the pin in 2nd Hole of Flyweel
Set the Flywheel mark at 13 Degree
Set the Flywheel mark at 0 Degree
Gear assembling order in Main shaft of FT Heritage 8+2 Gearbox is
R,1,2 & 3
2,R,1 & 3
1,2,3 & 4
All of the above
Recommended Sealant in Housing Joints of FT Gear box ,Rear axle anfd Hydraulic is
Paper Gasket
Anabond 666
Loctite 5182
Threebond 4252
When hydraulic lift circuit is in neutral, which valve will be in open condition
Control valve
Unload valve
Cylinder safety valve
Pressure relief valve
Draft Spring Adjustment value in FT Heritage models Hydraulics is
3.25 - 5.5 mm
1.12 - 1.40 mm
0.30 -0.40 mm
Mention the name of given valve
Control valve
Unload Valve
Cylinder safety valve
Check valve
Which Type of Rear axle reduction used in FT 6050 Heritage
To adjust position and draft control linkage ( Control valve adjustment) in FT Heritage hydraulics , the lift arm should be kept in
Upper position
Lower Position
In any Position
Pinion bearing preload in FT 6075 Heritage & FT 6050 Heritage should be
4 – 6 Kgf
7 - 9 Kgf
2 – 4 Kgf
10-12 Kgf
Above Shown parts are available in,
Gear Box
Epicyclic Rear Axle
4WD Front axle
The engine compression test must be performed with a cold engine
Yes
No
