WorksheetsPalm and Orbital Sander
Total questions: 14
Worksheet time: 7mins
What personal protection equipment should be worn when operating the finishing sander?
Safety Glasses
Dust Mask
Hearing Protectors
All of These
What happens to many walking surfaces in areas where finishing sanders are used?
They are difficult to see because of the saw dust covering.
They become slick because of the saw dust covering
The saw dust chemically reacts with the floor finish making it slick.
None of these.
If a finishing sander sparks excessively when being used what should be done?
Readjust the pad.
Replace the drive bearing which causes the sander to orbit.
Inspect, recondition or replace the brushes.
Check the electrical cord for continuity.
If the electrical cord is pulled out of the sander housing what should be done with the finishing sander?
Repair the cord before using the sander further.
Wrap the cord with a good quality electrical tape.
Continue to use the sander until it stops running then have the cord repaired
Cut the cord to prevent further use.
What does the grounding terminal look like on finishing sander?
Rectangular
Square
Round
Triangular
Finishing sanders use what size sand paper?
One-third sheet
One-quarter sheet
One-half sheet
All of these
How much pressure should the operator put on a finishing sander when sanding?
None
Light pressure
Medium pressure
Heavy pressure
What type of sandpaper should be used to complete most finishing sander jobs?
Course
Medium
Fine
Extra fine
What is number 3 pointing to?
Brush Holder
Trigger Switch
Handle
Paper Clamp
What is number 8 pointing to?
Aluminum Housing
Sanding Pad
Front Hand Knob
Paper Clamp
What is number 7 point to?
Sanding Pad
Paper Clamp
Handle
Aluminum Housing
What is number 6 pointing to?
Sanding Pad
Cord Strain Reliever
Brush Holder
Paper Clamp
What is number 5 pointing to?
Cord Strain Reliever
Handle
Paper Clamp
Aluminum Housing
What is number 9 pointing to?
Aluminum Housing
Sanding Pad
Brush Holder
Front Hand Knob
