NEW
Font size
WorksheetsBoiler 3-1 Feedwater Accessories
Total questions: 12
Worksheet time: 6mins
The feedwater system does what?
Prevents water from entering the boiler during start up.
Senses the flame during ignition
Supplies the proper amount of water to the boiler
Punt on third down
Maintaining the correct level of water is
Done with a bucket
Critical for safety and efficiency
Done only on start-up
Not important
Make up water is water added to the boiler to replace lost water from
Leaks in the system
Water loss during blowdown
Water loss to evaporation
All the answers
The ASME code requires all __________ to have a low water fuel cut off
Hydronic boilers
Coal fired boilers
Low pressure steam boilers
Hot water heaters
Low order fuel cut off testing by blow down must be performed
Daily or more often depending on the plant procedures
Only once a week because of lost water
Whenever the boiler operator feels like it
The third Tuesday in February
A Feedwater accessory is equipment
That is directly attached to the boiler
That is not directly attached to the boiler
Punts on third down
If the water level in the boiler is too high
The boiler could boil dry and explode
Carryover or priming could occur
Water will heat too quickly
I have a friend named Steve
A _____________ is a large condensate receiver
heating unit
blowdown tank
gate valve
surge tank
what type of valve has NO CHANGE in direction
a heart valve
a globe valve
a gate valve
a check valve
what type of valve allows flow in only one direction
a check valve
a globe valve
a gate valve
What valve is used to isolate the boiler from feedwater accessories
A Stop Valve
A Boil Valve
A Go Valve
A Check Valve
What type of valve is a "Wedge" type of valve?
Check
Gate
Globe
Stop at the Red Light
