NEW
Font size
WorksheetsHeavy Equipment Mod 5
Total questions: 15
Worksheet time: 8mins
Before connecting an attachment to a three-point hitch , the rockshaft should be set at what position?
Highest
In the middle
Minimum
Don't need it set.
Hydraulic fluid should be checked when?
Only when needed.
When its cold and machine is level.
When the fluid is hot.
With all cylinders fully extended.
Before connecting or connecting a PTO shaft what two things should you do first?
Block wheels of tractor and release the wheel brake.
Grease bucket and turn off tractor.
Disengage PTO and shut off engine.
Nothing hook that bad boy up.
Component that transfers power from transmission to rear axle is a ______.
Hydrocoupler
Drive Pan
Differential
Power Takeoff
The clutch that engages in one direction but spins free in the opposite is what kind of clutch?
Cone
Disk
Heavy Duty
Overrunning
A Tachometer indicates?
Wheel speed
Oil pressure
Total hours on machine
Engine speed
Hydrostatic transmissions allow infinite ______ adjustment of the tractor without shifting.
Torque
Speed
Maintenance
Horsepower
When an SCV is in the neutral position the cylinder should be?
Warm to the touch
Extended
Locked
creep slowly
When starting a gas tractor set the throttle to ?
low idle
1/3 to 1/2
1/2 to 3/4
None tractor should have a choke.
Optimum distance between the hitch and PTO shaft is?
7"
10"
8"
9"
Going up steep slopes what gear should you be in?
Highest
Lowest gear possible.
high reverse gear
3rd low range
When transporting an attachment where should the draw bar be placed?
Offset to the right.
Center fixed.
Offset to the left.
Lowest level.
If parking a tractor on a grade tractor should be parked at a right angle to?
The tree line.
Grade or Slope
Fuel station
Doesn't matter it has a parking brake.
The device to both pull and lift an attachment is a ?
PTO
three point hitch
Drawbar
Rockshaft Unit
The__________ prevents rear wheels of the tractor from slipping.
Range selector
Detent Valve
Differential Lock
Engagement lever.
