is the deformation if a material is caused by external forces. It is the ratio of the total change in

length of a material to its original length

The minimum one way slab thickness which is simply supported at the ends only is

Flat unobstructed areas exposed to wind flowing over open water for a distance of at least 2 km falls on

what exposure category for wind loading?

Zone 2 of the Philippine map has a wind velocity of ____Kph?

is the branch of mechanics that deals with bodies in a state of equilibrium.

is the branch of mechanics that deals with bodies in a state of equilibrium.

A structural system consisting of trusses in two directions rigidly connected at their

intersection. It is possible to have a rectangular system where the top and bottom chords of the

trusses are directly above and below one another. Triangular shapes are popular. A stiff

structure may span up to 1 05 meters.

Zone 1 of the Philippine map has a wind velocity of ____Kph?

Buildings used for college or adult education with a capacity of 500 or more students fall to what type of

occupancy?

The units are in newton-millimeter, kilonewton-meter or kipfeet.

the unit stress below which deformation is directly proportional to stress

A structure in which the loads are carried in two directions, first in the transverse direction

through each plate supported by adjacent plates and secondly in the longitudinal direction with

each plate acting as a girder spanning between v-ertical supports, since the plates act as

beams between supports. there are compressive stresses above the neutral axis and tensile

stresses below. These are usually constructed of reinforced concrete from 75 mm. to 150 mm.

thick

When a load is applied suddenly or changes rapidly, It is called a ____

A force can be considered acting anywhere along the line of action of the force if its direction

and magnitude do not change because of what principle?

Low rise buildings is an enclosed or partially enclosed with mean roof height less than or equal to?

Urban and suburban areas, wooded areas or other terrain with numerous closely spaced obstructions

having the size of single family dwelling or larger falls on what exposure category for wind loading?

This system is constructed so that the vertical and horizontal members work as a single

structural unit, in contrast to a simple post-and-beam system. This makes for a more efficient

structure because aH three members resist vertical and lateral loads together rather than

singly. The beam portion is partially restrained by the columns and becomes more rigid to

vertical bending forces, and both the columns can resist lateral forces because they are tied

together by the beam

Open terrain with scattered obstructions having heights less than 9M. Falls on what exposure category

for wind loading?

A force has both direction and magnitude and as such is called _____________

The minimum one way slab thickness for a ONE end continuous slab is

________________is a measure of the stiffness of the material of a structural member

Large city centers with at least 50% of the buildings having a height greater than 21M. falls on what

exposure category for wind loading?

The minimum one way slab thickness for a BOTH ends continuous slab is

Aviation control towers fall to what type of occupancy?