NEW
Font size
WorksheetsModule 3-Creating Vlans
Total questions: 12
Worksheet time: 6mins
What is the primary purpose of a vlan?
To reduce collision domains.
To separate tagged from untagged traffic.
To combine multiple types of network traffic into one broadcast domain.
To break up a large network layer 2 broadcast domain into smaller broadcast domains.
When does vlan tagging occur?
Frames are tagged when leaving the PC to the switch.
Frames are tagged when received on a switch port that is assigned to a vlan but destined for another network.
Frames are tagged by the router after the switch determines the destination address is on a remote network.
Tagged traffic never occurs anymore on modern intermediary devices.
Port Fa0/11 on a switch is assigned to VLAN 30. If the command no switchport access vlan 30 is entered on the Fa0/11 interface, what will happen?
Port Fa0/11 will be shutdown.
An error message would be displayed.
Port Fa0/11 will be returned to VLAN 1.
VLAN 30 will be deleted.
Which command would you use to verify that subinterfaces or SVI interfaces created for inter-vlan routing are in the routing table?
show interfaces [int-id] switchport
show ip route
show vlan
show ip int brief
Which command displays the encapsulation type, the voice VLAN ID, and the access mode VLAN for the Fa0/1 interface?
Which command displays the encapsulation type, the voice VLAN ID, and the access mode VLAN for the Fa0/1 interface?
show interfaces Fa0/1 switchport
show interfaces trunk
show mac address-table interface Fa0/1
Which command sets switch ports so they require manual configuration to specify trunking or nontrunking?
dynamic desirable
dynamic auto
nonegotiate
trunk
What type of VLAN is configured using the mls qos trust cos command to reserve bandwidth to create a delay of less than 150 ms across the network?
Voice
Native
Data
Trunk
Which distinct type of VLAN is used by an administrator to remotely access and configure a switch?
default VLAN
native VLAN
data VLAN
management VLAN
Which type of VLAN is used to designate which traffic is untagged when crossing a trunk port?
Data
Default
Native
Management
What command is used to designate a 802.1Q subinterface on a router as a native vlan interface?
Encapsulation dot1q 10 native
Switchport access vlan 10 native
Switchport trunk vlan 10 native
Switchport vlan 10 native
How is traffic routed between multiple VLANs on a multilayer switch?
Traffic is routed via subinterfaces.
Traffic is routed via dedicated physical interfaces.
Traffic is routed via SVI interfaces.
Traffic is broadcast out all physical interfaces.
While configuring inter-VLAN routing on a multilayer switch, a network administrator issues the no switchport command on an interface that is connected to another multilayer switch. What is the purpose of this command?
To create a routed port to an external network.
To provide a static trunk link.
To provide an access link that tags VLAN traffic.
To create a switched virtual interface.
