WorksheetsTolerance - IED
Total questions: 15
Worksheet time: 14mins
What tolerance format is marked in red in the drawing?
Unilateral Tolerance
Bilateral Tolerance
Limit Dimensions
Tolerance Dimensions
What tolerance format is marked in red in the drawing?
Unilateral Tolerance
Bilateral Tolerance
Limit Dimensions
Tolerance Dimensions
What tolerance format is marked in red in the drawing?
Unilateral Tolerance
Bilateral Tolerance
Limit Dimensions
Tolerance Dimensions
The bushing diameter must be at least 1.000 inches but can be no more than 1.005 inches.
The bushing diameter must be greater than 1.000 inches or less than 1.000 inches
The upper limit dimension is 1.005 inches
The actual diameter of the hole is 1.000 inches
The actual diameter is 1.250 inches
The size of the outer bushing diameter can vary betwen 1.249 inches and 1.255 inches
The outer bushing diameter can vary by no more than 0.003 inches greater than or less than the specified diameter of 1.252 inches
The size of the outer bushing diameter can vary between 1.252 and 1.255 inches
The contour raduis cannot be greater than 15 mm
All the deviation is less than the specified size of the dimension
The contour radius cannot be greater than 15 mm
The contour diameter can vary by at most 0.1 mm
The overall width of a part is specified to be 3.00 with a bilateral tolerance of 0.02 Write the tolerance as you would see on a dimensioned drawing?
3.02
3.00
3.00−0.00+0.02
3.00±0.02
3.02
2.98
A piece has a dimension of 54mm ± 0.5mm. What is the maximum acceptable length?
54.5 mm
53.5 mm
54.05 mm
53.95 mm
The maximum (upper) limit of a part is 4.01 mm and the minimum (lower) limit is 3.98 mm. What is the tolerance?
.035 mm
What is upper limit for this tolerance? 0.250±0.01
0.251
0.240
0.260
0.02
