All electrical equipment MUST be considered _____ before working on it.

The proper angle for setting up a ldder is to place the basea/an ____ of the working length of the ladder from the wall or other vertical surface.

The government organization whose purpose is to set and enforce worksite safety and health standards is

If the sacle of a blueprint indicates 1/8 inch equals 1 foot, then a line taht measures 10 inches would indicate a site measurement of

If the lighting requirement is 3 volt-amps per square foot and a home is 40 feet by 90 feet, the required volt-amps for lighting would be

The tool shown is known as ____ pliers

Which hammer is MOST commonly used by electricians?

What are industrial screwdriver blades made of?

What is this tool?

All power tools should be grounded and must have a 3-prong cord unless they are approved

Power tools should be carried by the

When working on a construction site, power tools should only be used if they are plugged into a/an _____ receptacle

An ohmmeter is used to measure

What is the MOST commonly used communication cable in residential voice/data applications?

What type of connector is this?

What type of cable has the largest amount of potential bandwidth?

Flexible metal conduit should be supported within ___ of an outlet or junction box.

According to the NEC< EMT conduit must be supported every

Finished conduit is produced in nominal ____ lengths

Which conduit is the thickest and needs to be threaded

Double-insulated tools are designed to prevent

The MINIMUM amount of free wire that must be left in a workbox is

What type of cable is used for service entrances?

Non-metallic sheathed cable must be supported ____ from every outlet or junction box.

To control a light fixture from 5 locations, which of the following switch combinations must be used?

Which of the following green technologies utilizes wind to produce electricity?

The NEC requires two grounding electrode rods to be placed in the ground a minimum of ____ apart

What is the minimum distance between straps on service entrance conductors?

What is the MINIMUM working space width required at the service panel?

Service conductors should have a clearance of not less than ___ from doors and windows designed to open

The National Electric Code (NEC) is published by

According the the NEC, a continuous load is one where the maximum current is expected to continue for ___ or more hours

The National Electric Code (NEC) term "accessible" means taht an electrical box can be

The MINIMUM clearance of ___ must be maintained between overhead service conductors and residential driveways