NEW
Font size
WorksheetsPSM Quiz 01
Total questions: 15
Worksheet time: 9mins
What is the purpose of a detailed investigation?
To identify responsible staff for penalisation
To enable corrective actions
To prevent recurrence of events
All of above
A bypass line and valve is to be added across a control valve for ease of maintenance, can this be carried out on subtle change?
Yes
No
Depends on Risk Level
Depends on EHS Verdict
What are current approx safe-man-hours at CPL?
1M
2M
10M
20M
As mentioned in DuPont Bradly Curve, what is Level 3?
Good System is mostly implemented
Fundamental Knowledge in organization
System is implemented and being used effectively and show signs of continuous improvement
None of the above
If a person injured during hot work and the subject hazard was not addressed in Job Safety Analysis. Which PSM element is violated?
Procedure & Performance Standard
Risk Assessment & Process Hazard Analysis
Incident Investigation
Quality Assurance
What is Safety Critical Equipment?
Devices whose failure could result in a release, major fire and explosion
Devices whose failure could result in a minor fire
Devices whose failure could interrupt production
None of the above
What is D-Level at CPL?
Departmental Safety Committee
Toolbox talk
Grass-root Safety Committee
Corporate Level Committee
General Managers are part of which team for Emergency Response?
Emergency Squad
Emergency Control Centre
Rear Control
none of these
What is a Safety Leading Indicator?
An indicator of utmost significance
Safety accidents that result in loss of life or property
Proactive measures that measure prevention efforts and recorded prior to an injury
All of the above
Which of the following is a lagging indicator
An employee reporting Unsafe Conditions
Audits highlighting behavioural issues in area
An injury of an employee at Work
All of the above
Who is responsible for ensuring PSSR before commissioning of new equipment?
Reliability
Area Owner
Projects
Sub EHS Technology
What is Cnergyico Safety Matrix?
Database containing safety incident data at Cnergyico
Portal where recommendations are marked to responsible staff
Training and Development Portal at Cnergyico
Incident Investigation Portal at Cnergyico
If a safety critical device has to be taken out of service for PM for 2 hours during normal plant operation, what protocol should be followed at CPL?
Management of Change
EHS Waiver
STSO
LTSO
A battery operated non-IS inspection equipment is to be used at Plant 1, which of the protocol should be followed?
EHS Waiver & PTW
EHS Dispensation & Hot Work Permit
Safety Over-ride
All of the above
If a steam line leakage is controlled by installing a clamp on the line, what special protocol should be followed for such repairs?
EHS Repairs Form
EHS Dispensation Form
Temporary Repair Form
Sub EHS Tech
