NEW
Font size
WorksheetsRec-101 Body Level 1
Total questions: 31
Worksheet time: 16mins
When checking that the RV is equipped with all seatbelts required, ensure that each seating location in the motorhome has a seat belt or is
clearly marked not to be used while the vehicle is moving
in a non-adjustable upright position
labeled with year of manufacture, model, and name or trademark
not able to seat more than one person
When making interior adjustments and cleaning up, make sure all seats are
facing each other
two to a section of the RV
securely anchored to the floor
in reclining position
When inspecting satellite dishes, verify they are mounted securely and that
it is on top of a wood pole
it is positioned facing the RV
the signal obtained from it is strong
weather caps are in place and in good condition
When inspecting interior electrical components,
make sure each light is on the entire time
turn each light on and off
make sure each light is off the entire time
turn some lights on and off
When performing an interior electrical inspection, verify the _____ volt DC ports have power
12
15
17
20
When in the motor home cockpit, test steering wheel adjustment and check that it is
able to make left and right turns
unlocked when turning the RV
shifted when it is in a slanted position
straight when it is in the straight position
When testing steering wheel adjustment, check for _____ when it is not turned to either side.
straightness
sturdiness
crookedness
heaviness
When performing PDI on the entrance and compartment doors, the technician should have keys to fit every lock. This means that _____ set(s) of keys should exist.
1
2
3
4
Inspect all entrance doors and drip caps for
burrs and scratches
corrosion
intact butyl and/or caulking
galvanic isolation
When performing PDI on the entrance and compartment doors, test operation of all compartment doors and _____ as necessary.
replace
dismantle
remodel
lubricate
When checking entrance doorsteps, _____ them if needed
remove
polish
paint
store
If a roof is not walk-on style and a technician must walk on it,
do not walk on the roof
use plywood as support
walk on the peak only
use any material as support
There are five types of roofing material used on RVs. They are aluminum, fiberglass, PVC, TPO, and
tin
cement sheeting
EPDM
Plasterboard
Ensure that _____ decals are on the unit.
anti-theft
standards certification
manufacturer’s
D.O.T
When performing a check of the exterior, look for cracks or holes in the
door panels
ladders
window screens and awnings
fiberglass and aluminum
RVs are required to have a minimum of _____exits located remote from each other.
3
4
5
2
Ensure exits operate with no more than _____ pounds of force required to open them.
10
20
40
50
What is shown in the picture?
truck camper
fifth wheel trailer
folding camper trailer
travel trailer
A folding camper has
one foldable side
no water hookups
no electrical hookups
collapsible sides
When performing PDI with a lift mechanism, make sure that all _____ corners are raised the same amount.
2
4
6
8
When performing PDI on a folding camping trailer, raise the roof
halfway up
three-quarters of the way up
a quarter of the way up
all the way up
What is shown in picture?
truck camper
folding camping trailer
fifth wheel trailer
sport utility trailer
At maximum, truck campers can sleep _____ people
3
4
5
6
Which of the following should be attached to the camper body?
portable stabilizing jacks
jack brackets
coupling device
brake controller
The piece of equipment that runs between the pickup and camper is called the
stabilizing jack
shore power cable
12 VDC umbilical cord
110 VAC coaxial cable
A technician must verify which weight capacity of a truck to use a truck camper?
towing capacity
suspension capacity
tire pressure
tongue weight
Verify which of the following weights regarding the adequacy of the pickup?
GVW
GTW
GVWR
tire size
When performing PDI on expandable rooms, slideout operation can be hindered by
type of window covering used
counter placement
location of windows and doors
location of furniture
When performing PDI on slide outs, verify alignments in open and closed positions
front to rear, top to bottom
top to bottom only
front to rear only
front to bottom, rear to top
Primary and secondary are two major types of
trim
roofing
sealant
cleaner
When checking seals that are already in an RV, a technician must
observe that they are visible
ensure they stretch
measure their lengths
map out and document them
