WorksheetsEngineering Technology September 2022 3
Total questions: 20
Worksheet time: 2hrs 40mins
A spanner having at least one end with an open jaw
Open ended spanner
Ring Spanner
Circlip Spanner
Tap
Which measuring instrument would be used for determining the size of the gap in a spark plug
Feeler gauge
Thread gauge
Radius gauge
Tape measure
A surface or datum surface is usually used for …
making flat surfaces on metal.
accurately marking off pieces of metal.
supporting round shafts for marking.
supporting work pieces.
A guillotine is used for …
removing metal gradually.
cutting sheet metal.
removing screws and bolts.
making scribed lines clearer.
A hydrometer is a tool for measuring …
the level of a liquid in a glass.
pressure of liquids.
density of liquids.
acid in a battery.
The correct grinding machine for sharpening drill bits, chisels and cutting tools is a/an … grinder.
pencil
pedestal
angle
bench
A tap is used for ........
a tool that is used to measure the diameter of a piston
has a sharp point and is used to draw lines on metal
used to hold small things and to bend, twist and cut wire
used to cut internal threads in a drilled hole
A DIVIDER is used for ........
a flat tool with a straight edge, often shaped like an L
used to draw circles on a metal plate
has a sharp point and is used to draw lines on metal
used to divide work pieces
An Outside micrometer is used for .....................
a tool that is used to measure the diameter of a piston
used to hold small things and to bend, twist and cut wire
used to draw circles on a metal plate
used to cut internal threads in a drilled hole
A SCRIBER .............
has a sharp point and is used to draw lines on metal
used to scribe lines on sheet metal
used for punching indents to be drilled
cleaning blade teeth
Pliers
used to hold small things and to bend, twist and cut wire
can be used for pulling out nails
a tool for cutting sheet metal
used for holding objects in confined spaces
True or false .................
Tape measures can become rusty and damaged if they are not stored in their proper place.
True
False
True or false ............
The correct sizes of drawing sheets are A7, A20 and A30.
False
True
True or false ..................
Use a piece of wood to stop a grinding machine when the ON/OFF button is not working.
False
True
True or false ...............
Power is the rate at which work is done.
True
False
A six-sided figure is called a (a)
An instrument used to measure and set angles
(a)
A gauge that is used to check for the concentricity of a work piece
(a)
The internal diameter of a cylinder
Bore
Cylinder
Radius
Circumference
A guided shaft that is used to exert pressure
Ram
shaft
cow
press
