WorksheetsCCNP: 1-30
Total questions: 30
Worksheet time: 18mins
What is the IPv6 address used by OSPFv3 non-DR/BDR routers to send link-state updates and link-state acknowledgments?
FF02::2
FF02::5
FF02::6
FF02::9
Refer to the exhibit. Both routers R1 and R2 are configured for OSPFv3 and are routing for both IPv4 and IPv6 address families. Which two destination addresses will R1 use to establish a full adjacency with R2? (Choose two.)
ff02::5
fe80::2
2001:db8:22::100
172.17.66.1
2001:db8:21:20::2
On an OSPF multiaccess network, which multicast address must a non-DR router use to send an LSU packet that contains new link-state information?
224.0.0.5
224.0.0.1
224.0.0.6
224.0.0.9
224.0.0.2
Which configuration will prevent two directly connected Cisco routers from forming an OSPFv2 neighbor adjacency?
configuring mismatched OSPF process IDs on two adjacent routers
configuring mismatched MTU values on two adjacent routers
configuring a router ID on two adjacent routers
configuring a LAN interface connected to a switch as a passive interface
Which type of OSPF link-state advertisement is a network LSA?
type 4
type 1
type 3
type 2
What advantage does WPA2 have over WPA?
WPA2 uses AES instead of TKIP.
WPA2 uses static key management.
WPA2 uses a 32-bit WEP key for encryption.
WPA2 allows the caching of key information.
Which situation is an example of EAP deployment?
when a wireless client sends its MAC address to the AP for authentication after being validated by the internal database of the AP
when a client communicates with a RADIUS server for authenticated access to the network through the AP
when unauthenticated clients associate with the AP
when both the AP and client are configured with the same key or secret word for authentication by the AP
The Cisco SD-Access Architecture controller layer provided which function?
It presents all information to the user via a centralized management dashboard.
It interconnects all of the network devices, thus forming a fabric of interconnected nodes.
It provides network automation and operational status information to the management layer.
It delivers data packets to and from the network devices participating in SD-Access.
Match the Cisco SD-WAN solution component with the description. (Not all options are used.)
VŠE JE SPRÁVNĚ - mrnout na obrázek
vManage Network Management System – enables centralized provisioning and simplifies network changes
vSmart controller – authenticates each SD-WAN router that comes online
vBond orchestrator – configured with a public IP address so that all SD-WAN devices in the network can connect to it
non – supports standard router features, such as OSPF, BGP, ACLS, QoS, and routing policies
Refer to the exhibit. A company adopts the hierarchical network model in the corporate LAN design. Layer 3 switches are deployed in the core and distribution layers. On which of the devices in this network should routing between workstation VLANs take place?
the distribution layer devices
the core and distribution layer devices
the access layer devices
the core layer devices
Refer to the exhibit. A network administrator needs to implement inter-VLAN routing on a hierarchical network. On which devices should the inter-VLAN routing be configured?
Gateway and CS1
Gateway, CS1, DS1, and DS2
AS1 and AS2
DS1 and DS2
Which QoS model uses the DSCP bits to mark packets and provides 64 possible classes of service?
DiffServ
FIFO
best-effort
IntServ
Which type of QoS marking is applied to Ethernet frames?
IP precedence
Cos
DSCP
Tos
Which feature is used by an MST region to send VLAN information to a switch that runs PVST+?
PVST translation mechanism
PVST simulation mechanism
PVST transition mechanism
PVST conversion mechanism
What is a solution to mitigate the MST misconfiguration with improper VLAN assignment to the IST?
Ensure that only VLANs in the same MSTI for a trunk link are pruned.
Ensure that the MST region name is consistent across MST regions.
Move the affected VLAN to an MSTI other than the IST.
Move all active VLANs to the IST.
Which three statements describe the building blocks that make up the IPsec protocol framework? (Choose three.)
IPsec uses encryption algorithms and keys to provide secure transfer of data.
IPsec uses Diffie-Hellman as a hash algorithm to ensure integrity of data that is transmitted through a VPN.
IPsec uses secret key cryptography to encrypt messages that are sent through a VPN.
IPsec uses Diffie-Hellman algorithms to encrypt data that is transferred through the VPN.
IPsec uses ESP to provide confidential transfer of data by encrypting IP packets.
Refer to the exhibit. What two commands are needed to complete the GRE tunnel configuration on router R1? (Choose two.)
R1(config-if)# tunnel source 172.16.2.1
R1(config-ifj#tunnel destination 209.165.202.129
R1(config-if)# tunnel destination 209.165.202.130
R1(config-if)# tunnel source 209.165.202.130
R1(config-if)# tunnel source 209.165.202.129
What are two reasons for creating an OSPE network with multiple areas? (Choose two.)
to ensure that an area is used to connect the network to the Internet
to provide areas in the network for routers that are not running OSPF
to reduce use of memory and processor resources
to simplify configuration
to reduce SPF calculations
On what type of OSPF router is interarea route summarization configured?
intra-area routers
ABRs
backbone routers
ASBRs
Cisco has created a security framework to help protect networks from ever-evolving cybersecurity threats. What is the term given to a system that provides tools, such as breach detection, tracking, analysis, and surgical remediation, that organizations can use when advanced malware has slipped past other defenses?
AnyConnect
Talos
Threat Grid
Advanced Malware Protection (AMP)
Refer to the exhibit. What are the possible port roles for ports A, B, C, and D in this RSTP-enabled network?
altemate, root, designated, root
alternate, designated, root, root
designated, root, alternate, root
designated, alternate, root, root
Refer to the exhibit. All the displayed switches are Cisco 2960 switches with the same default priority and operating at the same bandwidth. Which three ports will be STP designated ports? (Choose three.)
fa0/10
fa0/21
fa0/13
fa0/20
fa0/11
Which two statements describe characteristics of load balancing? (Choose two.)
Load balancing occurs when a router sends the same packet to different destination networks.
Unequal cost load balancing is supported by EIGRP.
Load balancing occurs when the same number of packets are sent over static and dynamic routes.
Load balancing allows a router to forward packets over multiple paths to the same destination network.
If multiple paths with different metrics to a destinations exist, the router cannot support load balancing.
Refer to the exhibit. Which type of IPv6 static route is configured in the exhibit?
fully specified static route
directly attached static route
recursive static route
floating static route
A network administrator has noticed an unusual amount of traffic being received on a switch port that is connected to a college classroom computer. Which tool would the administrator use to make the suspicious traffic available for analysis at the college data center?
SNMP
DHCP snooping
RSPAN
TACACS+
802.1X
What are two benefits of using SNMP traps? (Choose two.)
They limit access for management systems only.
They reduce the load on network and agent resources.
They eliminate the need for some periodic polling requests.
They can passively listen for exported NetFlow datagrams.
They can provide statistics on TCP/IP packets that flow through Cisco devices.
How will user traffic be forwarded between two laptops that are both connected to the same lightweight access point in a large enterprise topology?
The lightweight access point will forward the traffic through a CAPWAP tunnel to a WLC and receive the return traffic from the WLC to forward to the other laptop.
The lightweight access point will forward the traffic through an upstream router and receive the return traffic from the router to forward to the other laptop.
The lightweight access point will forward the traffic on a trunk link to a distribution layer switch for routing and receive the return traffic to forward to the other laptop
The lightweight access point will switch the traffic between both laptops immediately.
A wireless engineer is deploying an autonomous Cisco access point. What must be configured on the access point to enable remote management?
management IP address
CISCO-CAPWAP-CONTROLLER. localdomain target
TFTP server IP address target
DHCP option 43
Which three protocols are components in the operation of 802.1x? (Choose three.)
TACACS+
EAPoL
EAP
RADIUS
IPsec
Match the security platform to the description. (Not all options are used.)
VŠECHNY JSOU SPRÁVNĚ - MRKNI NA OBRÁZEK
Cisco Firepower Management Center
Cisco identitity Services Engine
Cisco Stealthwatch
