WorksheetsHAC101 Week 2 Quiz Heating & Ventilation
Total questions: 20
Worksheet time: 10mins
Tech A says that the engine thermostat controls the flow of coolant through the heater system. Tech B says that the heater core can have engine coolant or refrigerant flowing through it, depending on whether heat or cool is commanded. Who is correct?
Select one:
Tech A
Tech B
Both A and B
Neither A nor B
What is a common coolant mixture ratio of coolant to water in the average vehicle?
Select one:
10% coolant to 90% water
50% coolant to 50% water
80% coolant to 20% water
15% coolant to 85% water
Some automotive manufacturers are using activated ______ cabin filters, which help trap odors and airborne pollutants such as carbon monoxide and oxides of nitrogen.
Select one:
Oxygen
Nitrogen
Carbon
Charcoal
Too strong of an antifreeze mixture in the vehicle's cooling system can cause:
Select one:
poor cooling.
overcooling.
a binding water pump.
None of the answers listed.
As the engine heats up from the process of burning fuel to create power, the coolant in the engine is also heated, reaching operating temperatures of approximately:
Select one:
180 - 220°F
150 - 175°F
255 - 290°F
None of the answers listed
Air doors are controlled by any of these methods, EXCEPT:
Select one:
cables.
vacuum servos.
slave cylinders.
electric servos.
The defrost time of passenger vehicles has decreased considerably because of the air-conditioner being switched on during the defrost cycle.
Select one:
True
False
Reversing the refrigerant flow through the air-conditioning system would turn your condenser core into an evaporator and provide ample heat for the passenger compartment.
Select one:
True
False
At what mileage increment should in-cabin air filters usually be replaced?
Select one:
2,000 - 3,000 miles
5,000 - 7,500 miles
12,000 - 15,000 miles
25,000 - 30,000 miles
Raising the pressure of water 1 psi (7 kPa) raises the boiling point of water approximately _____°F.
Select one:
1
2
3
4
Blend doors can be operated:
Select one:
mechanically.
by vacuum.
by electric motor.
All of the answers listed.
The highest blower motor fan speed uses how many resistors to achieve full blower fan speed?
Select one:
0
1
2
3
The resistor pack or resistor block uses resistors in _______ to regulate the speed of the blower motor fan.
Select one:
Parallel
Series
Modified parallel
All of the answers listed
When the air-conditioner is allowed to operate during the defrost cycle, the air is dried from the moisture removal occurring as air passes over the compressor before passing over the heater core.
Select one:
True
False
Normally, ______ of an electrical circuit is done by controlling "on" time compared to "off" time on the ground side of the circuit.
Select one:
Variable resistance
Pulse width modulation
Both A and B
Neither A nor B
Name the part.
Evaporator core
Heater Control Core
Thermostat
Heater Core
Name the part?
Heater control valve
Blower motor resistor
Actuator motor
Thermostat
Name the part?
Actuator valve
Heater control valve
Orifice tube
Blower motor resistor
Name the part?
Cabin filter
Actuator motor
Heater control valve
Blend door
Name the part?
Blend door
Cabin filter
Air filter
Thermostat
