Select the word or term that fits the sketch.

The organization, office, or individual responsible for enforcing the requirements of a code or standard is the _________________________.

Fixture connections that require the removal of an access panel for servicing are considered _______.

That part of the lowest piping of a drainage system that receives the discharge from soil, waste, and other drainage pipes inside the walls of the building and conveys it to a point 2 feet outside the building wall is a _____.

That portion of a drainage system that does not drain by gravity into the building sewer is known as a _____.

A horizontal drain that is sized to provide free movement of air above the flow line of the drain is called a _____.

The pipe from the source of supply to a building or structure is the _____.

A room equipped with a shower, bathtub or combination bath/shower is a ___________________.

An outlet on a boiler to permit emptying or discharging of sediment is called a(an) _______________.

A device installed in a drainage system to prevent reverse flow is a __________________________.

A combined building sewer is (a) __________________________.

When a backflow prevention device does not bear a critical level marking, the part of the device that shall constitute the critical level is the _____.

A medical gas system whose failure can cause minor injury to patients is defined as Category _______.

A standard that is an extensive compilation of provisions covering broad subject matter is the definition for______________.

A vertical vent that is a continuation of the drain to which it connects is a _______________________.

A circuit vent connects to a horizontal drain branch and vents _____ traps and not more than _____ traps from a battery of fixtures.

A pipe inside a building that conveys storm water from the roof to a storm drain, combined building sewer, or other approved point of disposal is called a(an) ______.

Select the word or term that fits the sketch.

A water heater that is constructed and installed so that all air for combustion is derived directly from the outside atmosphere and all flue gases are discharged to the outside atmosphere is a (an) _____.

The length along the centerline of the pipe and fittings is the __________________.

A device located at the bottom of the tank for the purpose of flushing water closets and similar fixtures is a _____.

A device integrated within an air accumulator vessel that is designed to discharge a predetermined quantity of water to fixtures for flushing purposes is a (an) _________________________.

Grounding electrodes are devices that establish an electrical connection to the _____.

Gray water is untreated household wastewater that has not come in contact with ?

The definition of gray water is _____.

Select the word or term that fits the sketch.

Select the word or term that fits the sketch.

Unsanitary and insanitary share the same meaning.

Select the word or term that fits the sketch.

The lowest portion of the inside of a horizontal pipe is called the _______________.

A joint obtained by the joining of metal parts with metallic mixtures or alloys that melt at a temperature up to and including 840° F is a _______________________.

The principal artery of the venting system to which branches may be connected is called the _____.

Air supplied from cylinders, bulk containers or reconstructed from oxygen USP is defined as Medical ______.

The part of the horizontal piping of a drainage system that begins _____ feet downstream from the last mobile home site and conveys it to a public sewer is called a mobile home park sewer.

The restroom facilities in a private day care center are classified as public use.

Select the word or term that fits the sketch.

PEX is defined as _____.

Static pressure is pressure existing without any flow.

Water that is satisfactory for drinking, culinary and domestic purposes and that meets the requirements of the Authority Having Jurisdiction is referred to by this code as _____.

Reclaimed water systems are defined as follows ?

A document, the main text of which contains only mandatory provisions using the word ? “shall? ” to indicate requirements, is best described as a _____.

By code definition, a stack is always _____.

The definition for the word “stack” does not include _____.

A permanently installed mechanical device, other than an ejector, for removing sewage or liquid waste from a sump is called a sewage pump?

In a medical gas system, SCFM means _____.

Select the word or term that fits the sketch.

The vertical depth of a trap seal is measured from _____.

A device and system of piping that maintains a water seal in a remote trap is called a trap primer.

Select the word or term that fits the sketch.

A mixing valve that senses outlet temperature and compensates for fluctuations in incoming hot or cold water temperature is a__________________________.

In a medical gas system, A valve that controls the gas or vacuum service to a particular area is a (an) _____.

A pipe that makes an angle of 45 degrees from the vertical is considered _____ ?

50. In a medical gas system, the service valve serves _____.

The combination of fittings that may be used to make an offset and is considered a vertical pipe are _____.

A pipe that makes an angle of not more than 45 degrees with the vertical is considered ____________.

Any pressure less than that exerted by the atmosphere is a (an) __________________________.

The discharge from clinical sinks and conveyed to the building drain is defined as a waste pipe.

A device designed to provide protection against hydraulic shock in the building water supply system is called a (an) _____.

A water heater is by definition an appliance for_________________________________.

A vent that also serves as a drain is a(an) ____________________.

Select the word or term that fits the sketch.

Select the word or term that fits the sketch.