2. Fittings on screwed drainage pipe shall be of (the) ______________________.

3. Threads in drainage fittings shall be tapped to allow for _____.

4. The minimum size trap and trap arm for a bathtub is_______________.

5. The minimum size drain line for a wall-hung urinal is _____ inches

6. A domestic dishwasher, with independent drain, has a drainage fixture unit value of _____.

7. The minimum size trap at "D" is ______________.

8. The number of fixture units at "C" is __________.

9. The minimum size trap arm at "G" is ____ inch.

10. The total number of fixture units at "A" is __________.

11. The building sewer and water piping may be installed in the same trench (with the proper clearances) if the building sewer piping is _____.

12. The minimum sizes of vertical and horizontal drainage shall be determined from the _____.

13. The maximum fixture units allowed on a 4-inch horizontal drain with a 1/8 inch per foot slope is _______.

14. Because of structural conditions, a 4-inch building drain is installed with a slope of 1/8 inch per foot. This installation will result in _____.

15. The minimum size pipe at "B" is _________________.

16. The minimum size pipe at "A" is _________________.

17. The maximum fixture unit loading allowed on a 2-inch waste stack is ________________.

18. After caulking a lead joint in a cast iron hub, the finished joint shall not exceed _____ of an inch below the rim of the hub.

19. Of those listed the acceptable fitting for connecting a horizontal drain line with another horizontal drain line is a _____.

20. Of those listed, the appropriate fitting at “E ” would be a _____.

21. Vertical drainage lines connecting with horizontal drainage lines shall enter through a _____.

22. The cleanout at "F" shall be at least _________________.

23. Cleanouts shall be designed to be ____________________________.

24. With few exceptions, all horizontal drainage piping shall be provided with a cleanout at _____________________.

25. The clearance required in front of a 2-inch cleanout shall not be less than _______________.

26. Three-inch horizontal drainage piping shall have a grade or slope of not less than _______________.

27. The minimum size discharge pipe from an ejector or pump in a single dwelling unit having a water closet connected thereto is _____.

29. A horizontal drain pipe has an existing load of 30 fixture units, after connecting the discharge pipe from an ejector rated at 60 gpm, the total load on the horizontal drain pipe will be _____________________.

30. Dual sewage ejectors for public use require _____ alarm.

31. Macerating toilet systems shall be permitted _____.

32. Sumps for macerating toilets shall be ____________________________.

33. Except in single-family residences, drainage stacks 3 stories or more in height serving _____ are considered suds-producing fixtures.

34. Drainage connections shall not be made into a drainage piping system within _____ of any vertical to horizontal change of direction of a stack containing suds-producing fixtures.

35. Except for plastic pipe, in lieu of water test, drainage piping may be tested with _________________.

36. The building sewer and water piping may be installed in the same trench (with the proper clearances) if the building sewer piping is _____.

37. The drainage fixture unit value assigned to a bathtub or combination bath/shower is _____.

38. The maximum trap loading for a 3-inch trap is _______________.

39. The maximum discharge capacity for intermittent flow only, in gallons per minute, for one fixture unit is equal to _____.

40. The maximum number of fixture units allowed on a 4-inch building sewer with a slope of 1/8 inch per foot, as compared to a 4-inch building sewer with a slope of 1/4 inch per foot is _____.